What is the poH of a
2.6 x 10-6 M H+ solution?
pOH = [?]

Answer:

Freezing the mix is one of the most important operations in making ice cream, for upon it depend the quality, palatability, and yield of the finished product. Typically, freezing of ice cream is accomplished in two steps: (1) dynamic freezing, where the mix is frozen quickly while being agitated to incorporate air and to limit the size of ice crystals formed; and (2) static freezing, where the partially frozen product is hardened without agitation in a special low-temperature environment designed to remove heat rapidly. Although these steps primarily encompass freezing, or the formation of ice crystals, there are several other important processes that take place during this time that significantly impact the quality of ice cream. Both the dispersion of air bubbles and rearrangement of fat globules occur during the freezing steps.

Explanation:

Answer:

Increase

Explanation:

Hope it helps you

Answer:

Decrease

Explanation:

If the oil you're referring to is just some normal oil, it'll lessen the friction and cause it to side more smoothly

Answer:

It does not matter where the sample of water came from or how it was prepared. Its composition, like that of every other compound, is fixed.

Answer:

Here's the Sample Response: The reactants and products determine the type of chemical reaction. If there are more products than reactants, then it is a decomposition reaction. If there are more reactants than products, it is a synthesis reaction. If oxygen is a part of the reactant, it is a combustion reaction. If one ion replaces another, it is a single replacement reaction. If there are two compounds in a reactant where cations switch, it is a double replacement reaction.

Explanation:

Answer:Avogadro's number 6.02 x 10^23 of O2 molecules has a mass of 32 gm (atomic weight of O = 16 gm, 2 x 16 = 32).

Explanation:pls brainless

Answer:

The ricks were degraded over time by wind and water and were crushed down into tiny, smaller rocks, which is sand.

Explanation:

This is my first answer sorry im not that smart

Answer:

Most of these rocks are not made up of common geometric shapes

Explanation:

Because most rocks are not made up of common geometric shapes, it would be difficult or impossible to find the volume of a rock using a ruler; there would be no easy way to measure the rock's volume using a ruler

Hope this helped!

Molarity of solution = 1.6 M

Given

40 g NaOH

6 L solution

Required

Steps to solve the problem of molarity

Solution

No additional information about the question.

If you want to make the solution above, then we just need to put the existing NaOH (40 g) into 6 L of water, then do the stirring (in a warm temperature above the hot plate will speed up the NaOH dissolving process)

But if you want to know the molarity of a solution, then

[tex]\tt mol=\dfrac{mass}{MW}[/tex]

MW(molecular weight) of NaOH=

Ar Na+ Ar O + Ar H

23 + 16 + 1 = 40 g/mol

so mol NaOH :

[tex]\tt mol=\dfrac{40~g}{40~g/mol}=1~mol[/tex]

[tex]\tt M=\dfrac{n}{V}\\\\M=\dfrac{1}{6}\\\\M=0.16[/tex]

Answer: The empirical formula is [tex]H_4P_2O_7[/tex]

Explanation:

If percentage are given then we are taking total mass is 100 grams.

So, the mass of each element is equal to the percentage given.

Mass of H= 2.270 g

Mass of P = 34.80 g

Mass of O = 62.93 g

Step 1 : convert given masses into moles

Moles of H =  [tex]\frac{\text {given mass}}{\text {Molar mass}}=\frac{2.270g}{1g/mol}=2.270[/tex]

Moles of P =  [tex]\frac{\text {given mass}}{\text {Molar mass}}=\frac{34.80g}{31g/mol}=1.122[/tex]

Moles of O = [tex]\frac{\text {given mass}}{\text {Molar mass}}=\frac{62.93g}{16g/mol}=3.933[/tex]

Step 2 : For the mole ratio, divide each value of moles by the smallest number of moles calculated.

For H =  [tex]\frac{2.270}{1.122}=2[/tex]

For P=    [tex]\frac{1.122}{1.122}=1[/tex]

For O =   [tex]\frac{3.933}{1.122}=3.5[/tex]

The simples ratio will be = H: P : O= 4: 2: 7

Hence the empirical formula is [tex]H_4P_2O_7[/tex]

Answer:

Because its source is the almost unlimited amount of heat generated by the Earth's core. Even in geothermal areas dependent on a reservoir of hot water, the volume taken out can be reinjected, making it a sustainable energy source.

Explanation:

Geothermal energy is underutilized and underutilized in comparison to other renewable energy sources such as solar and wind energy. This is due to the difficulty of extracting energy from the subsoil, as complications can arise that affect both the environment and the cost of energy.

Geothermal energy is the thermal energy in the Earth's crust that results from the planet's formation and radioactive decay of materials in currently unknown but potentially roughly equal proportions.

Geothermal energy is not always a renewable energy source because the extraction of heat from the earth's crust over time can cause depletion, causing some geothermal wells to cool and run out of water.

Geothermal energy can be found at depths accessible by drilling in these areas. It is simply too deep to reach in other parts of the world. The second reason is that it has high capital expenses. The costs of drilling and power plants are somewhat high.

Thus, Geothermal energy is underutilized and underutilized in comparison to other renewable energy sources such as solar and wind energy.

To learn more about geothermal energy, follow the link;

https://brainly.com/question/1061324

#SPJ5

Answer:

hope this help

Explanation:

change: volume of solid , volume of liquid , the volume of gases

not change: the shape of solid , the shape of liquid , the shape of gases

Answer:

1)A mixture that is easily separated, the components are different sixes and unevenly mixed.

Explanation:

Mixtures are impure substances with usually indefinite composition. Their constituents often retains their identities. They can easily be separated into constituents by physical methods.

Homogenous mixtures have their constituents existing in only one phase.

Heterogeneous mixtures have their constituents existing in at least two different phases.

Answer:

CH2O is formaldehyde a covalent compound and its intermolecular forces are week

KCl is an ionic compound formed by electrostatic force of attraction between positive and negative charge. Ionic compounds also exists in three dimensional crystal lattic that is why intermolecular forces in KCl is stronger.

Moreover melting point of KCl is higher than CH2O

Explanation:

Answer:

the l sign means the substance in the chemical equation is a liquid. (hope this helped : D )

Answer:

All ions must a overall charge

Explanation:

Answer:

i belive its B

Explanation:

Explanation:

It looks like 2,2,4-trimethylpentane.

Longest alkane chain contains 5 carbons. => -pentane

3 methyl groups on the 2nd, 2nd and 4th carbons.

Answer:

Boat conformation cis 1,4-dimethyl cyclohexane has the highest energy.

Explanation:

From the conformations, the boat conformation cis 1,4-dimethyl cyclohexane is least stable due to the fact that two methyl groups are located in opposite direction to each other, this leads to the production of  a higher strain. Similarly, Chair conformations appear more stable than boat conformation. Hence, energy is inversely proportional to stability. As a result of the aforementioned, boat conformation cis 1,4-dimethyl cyclohexane has the highest energy.

Why can gases and liquids be paired but not solids?

The atoms and molecules in gases are much more spread out than in solids or liquids. They vibrate and move freely at high speeds. A gas will fill any container, but if the container is not sealed, the gas will escape. Gas can be compressed much more easily than a liquid or solid.

Answer:

The Earth’s greenhouse effect is a natural consequence of the chemical makeup of its atmosphere. If it

were not for the greenhouse effect, life as we know it could not exist on Earth: it would be too cold. Our

atmosphere is made mostly of nitrogen and oxygen, but also contains several other gases. These include

carbon dioxide, methane, nitrous oxide, water vapor and ozone, which are known as greenhouse gases.

Greenhouse gases are released naturally through geologic processes and the metabolic activity of living

things. However, there is an ongoing debate over human effects on Earth’s global climate. Human industrial activity on the planet has increased the quantities of greenhouse gases through agriculture, manufacturing, power generation, and engines used for transportation. Key questions include: Is the average temperature of Earth increasing? Does the presence of human beings contribute to global warming? If the temperature of Earth does become warmer, how will it affect us?

Explanation:

Answer:

A the first one

Explanation:

Answer:

The Answer is fjords

Explanation:

Hope It Helps! Make Me Braninest

Answer:

Kichi made the an error in the 2nd row which is Sulfuric acid.

Sulfuric acid would be found in the garage because it is used in car batteries

Explanation:

Ammonium hydroxide (NH4OH) is used in household cleaners.

Sulfuric acid (H2SO4) is used in industrial chemicals and car batteries.

Citric acid (H3C6H5O7) is in lemons, limes, and oranges.

Potassium hydroxide is used in batteries.

Kichi made a mistake while locating sulfuric acid which is an acid and is used car batteries ,hence it should be found in garage rather than in cosmetics bag.

Acids are defined as substances which on dissociation yield H+ ions , and these substances are sour in taste. Compounds HCl, H₂SO₄ and HNO₃ are acids as they yield H+ ions on dissociation.

According to the number of H+ ions which are generated on dissociation acids are classified as mono-protic , di-protic ,tri-protic and polyprotic  acids  depending on the number of protons which are liberated on dissociation.

Acids are widely used in industries  for  production of fertilizers, detergents  batteries and dyes.They are used in chemical industries for production of chemical compounds like salts which are produced by neutralization reactions.

Learn more about acids,here:

https://brainly.com/question/1512259

#SPJ5

The equations that show a precipitation reaction would be [tex]MgSO_4(aq) + CaCl_2(aq) --- > MgCl_2(aq) + CaSO_4(s)[/tex], [tex]FeCl_2(aq) + Na_2CO_3(aq) --- > FeCO_3(s) + 2NaCl(aq)[/tex], and [tex]2AgNO_3(aq) + Na_2S(aq) --- > Ag_2S(s) + 2NaNO_3(aq)[/tex]

It is a reaction in which two soluble salts react in aqueous solutions to form one soluble and one insoluble salt.

Thus, all the equations with an insoluble salt as one of the products will qualify as precipitation reactions. The insoluble is designated as (s).

Hence, the following are precipitation reactions:

More on precipitation reactions can be found here: https://brainly.com/question/24158764

#SPJ2

Answer:

O3S

Sulfur Trioxide

Explanation:

Answer:

so that people would be able to witness the inauguration of a president, since a president is an important part of a country.

Explanation:

Answer:

1. nitrous oxide

2. copper sulfide

3. cl2o7

4. MgBr2

Explanation:

hope it helps

Answer:

Molar mass = 99 g/mol

Explanation:

Phosgene contains carbon, oxygen and chlorine atoms. Its molecular formular is; COCl2

The molar mass is given as the sum off the individual atomic mass of the elements in the compound.

Molar mass = C + O + 2Cl

Molar mass = 12 + 16 + 2(35.5)

Molar mass = 99 g/mol

Answer:

0.00047212

Explanation:

Given parameters:

Quantity of dumps  = 3.0099 dumps

Unknown:

Amount of wigs in this dumps = ?

Solution:

Since it is given that;

                 6375.23 dumps  = 1 wig

 To find 3.0099dumps;

                3.0099 dumps  =  x wigs

             6375.23x  = 3.0099

                           x  = [tex]\frac{3.0099}{6375.23}[/tex]   = 0.00047212 wig

Answer:The potential energy of the shared elec- trons is lower in the bond than it would be if the electrons were not shared between two nuclei

Explanation:

The entire essence of chemical combination is the attainment of a lower potential energy.

When two atoms are isolated at a large distance from each other, the potential energy is high.

However as the nuclei of the two atoms approach each other, the potential energy decreases until a minimum is attained. The distance between the nuclei at this point is the bond distance.

Hence, the potential energy of the shared electrons is lower in the bond than it would be if the electrons were not shared between two nuclei.

Answer:

Dichlorine heptoxide=Cl₂O₇

magnesium bromide=MgBr2

Explanation: