What chemical property determines the strength of an acid?.

i love jesus and i love my mommy

Cross-section of a metal wire wrapped in plastic insulation the metal wire is an element.

An element is a substance or material that cannot be affected by an external substance or cannot be broken down by any reaction.

Metal wire is serving as an element, it should not be easily broken or penetrated as an insulator.

Therefore, Cross-section of a metal wire wrapped in plastic insulation the metal wire is an element.

Learn more on element here,

https://brainly.com/question/18096867

Answer: b. population will decrease

Explanation:

since earth only has a finite amount of resources, it could only support a set amount of people. once these sources can no longer be used, the population will decrease because resources can no longer support the population.

Answer:

The mass of NaCl needed for the reaction is 91.61 g

We'll begin by calculating the number of mole of F₂ that reacted.

Volume (V) = 12 L

Temperature (T) = 280 K

Pressure (P) = 1.5 atm

Gas constant (R) = 0.0821 atm.L/Kmol

Number of mole (n) =?

PV = nRT

1.5 × 12 = n × 0.0821 × 280

18 = n × 22.988

Divide both side by 22.988

n = 18 / 22.988

n = 0.783 mole

Next, we shall determine the mole of NaCl needed for the reaction.

F₂ + 2NaCl —> Cl₂ + 2NaF

From the balanced equation above,

1 mole of F₂ reacted with 2 moles of NaCl.

Therefore,

0.783 mole F₂ will react with = 0.783 × 2 = 1.566 moles of NaCl.

Finally, we shall determine the mass of 1.566 moles of NaCl.

Mole = 1.566 moles

Molar mass of NaCl = 23 + 35.5 = 58.5 g/mol

Mass of NaCl =?

Mass = mole × molar mass

Mass of NaCl = 1.566 × 58.5

Mass of NaCl = 91.61 g

Therefore, the mass of NaCl needed for the reaction is 91.61 g

Explanation:

Answer:

Measure so that the line you are reading is even with the center of the meniscus. For water and most liquids, this is the bottom of the meniscus. For mercury, take the measurement from the top of the meniscus. In either case, you are measuring based on the center of the meniscus.

Explanation:

Answer:

Answer one:
Solute particles block some of the ability of liquid particles to evaporate. We can then conclude, solutions of solid solutes typically have a lower vapor pressure than pure solvents.

Answer two:
Solutions freezing points are lower than of the pure solvent or solute because freezing (becoming a solid) creates order and decreases entropy.

Answer three:
The presence of solute particles decreases the vapor pressure of the liquid solvent, this means a higher temperature is needed to reach the boiling point.

Explanation:

Have a great rest of your day
#TheWizzer

Answer:

C LiOH

Explanation:

because it is an hydroxide as well as it is alkaline

Answer:

C. LiOH

Explanation:

LiOH is a strong base while the others are acids

Answer:

Explanation:

Nitric Acid (HN03)

Zn(OH)2 + 2HNO3 ==> Zn(NO3)2 + 2HOH

The salt and water are a homogeneous mixture but when salt dissolves in the water system is called a solution of salt and water.

A mixture is defined as the combination of two or more substances that are not chemically bonded together.

There are two types of mixture which include:

When salt is added to the ice water system, it lowers the freezing point of the ice water thereby forming a homogenous mixture of water and salt.

The dissolution of salt in ice water leads to the formation of salt and water solution.

Learn more about mixture here:

https://brainly.com/question/10677519

Answer:

Pb(NO

3

)

2

+

2

KI

→

PbI

2

+

2

KNO

3

Explanation:

Answer: 373 mL

Explanation:

Since there is no change in pressure, the formula: V / T = V / T can be used.

However, you must first convert the temperatures to Kelvin by adding 273 to them:

(19 + 273) = 292K and (90 + 273) = 363K.

Now, plug in: V / 292 = 464 / 363 → V = 373 mL :)

D. Water

At an unchanged temperature and pressure, if the amount of gas increased by the given value, the final or new volume of the gas is 9.33L

Avogadro's law states that equal volumes of different gases contain an equal number of molecules provided temperature and pressure remains in the same conditions. It is expressed;

V₁/n₁ = V₂/n₂

Given the data in the question;

To determine the new volume, we substitute our given values into the expression above.

V₁/n₁ = V₂/n₂

V₁n₂ = V₂n₁

V₂ = V₁n₂/n₁

[tex]V_2 = \frac{5.00L * 1.80mol}{0.965mol}\\\\V_2 = \frac{5.00L * 1.80}{0.965}\\\\V_2 = \frac{9L}{0.965} \\\\V_2 = 9.22L[/tex]

Therefore, at an unchanged temperature and pressure, if the amount of gas increased by the given value, the final or new volume of the gas is 9.33L

Learn more about Avogadro's law: https://brainly.com/question/3491421

Here is a Answer to your question:

Air pollution is caused by solid and liquid particles and certain gases that are suspended in the air. These particles and gases can come from car and truck exhaust, factories, dust, pollen, mold spores, volcanoes and wildfires. The solid and liquid particles suspended in our air are called aerosols.

Here are the 8 causes of air pollution?

1: The Burning of Fossil Fuels

2: Industrial Emission

3: Indoor Air Pollution

4: Wildfires

5: Microbial Decaying Process

6: Transportation

7: Open Burning of Garbage Waste

8: Construction and Demolition

I am sorry if this was not helpful

Hope this was helpful

Answer:

Fiddlehead

Explanation:

Young fronds are called Fiddleheads

because of how they are coiled

Answer:

Fiddleheads or koru

Explanation:

The coiled, immature leaves are called fiddleheads. Young fronds, called fiddleheads because of their striking resemblance to the head of a violin, start out tightly curled at the base of the root. New, or young fronds are produced from the rhizome. They are tightly coiled into a spiral (called a fiddlehead or koru), and these slowly uncoil as they mature.

Isotopes are only formed in laboratories and is denoted as option D.

This refers to an element which has the same atomic number but different mass number due to difference in number of neutrons.

They are also usually formed in laboratories through series of chemical reactions.

Read more about Isotopes here https://brainly.com/question/6258301

#SPJ1

To calculate the molar volume of a gas at STP you can use the ideal gas law equation,

PV=nRT

Regardless of what ideal gas you use, the molar volume at STP will be identical across the board, since you'll be using 1 mole in the ideal gas law equation regardless of what gas you're dealing with.

That is why the volume occupied by 1 mole of any ideal gas will be equal to 22.7 L at STP.

22.4L = 1 mol

38.0L = ?

= 38/22.4

=1.6964285714 Moles

Answer:

b. nuclear fuel has a higher energy density than fossil fuels.

Explanation:

Nuclear fuel is a quantity of energy measured in joules; therefore, it has the same units as electrical and mechanical energy.

Answer:

0.01134kg

Explanation:

You divide by 1000 to get the kg

Answer:

The enthalpy of vaporization of a given substance is much greater than its enthalpy of fusion because it takes more energy to completely separate molecules (c

A 120g block of pinewood has a volume of 300cm3. Would this block float on water? (HINT: Water has a density of 1g/cm3). a. No, because the block is denser than water.

Also here's a free meme

The density of a material represents the denseness of that material in a specific given area. If an object has a density less than water then it will float on water otherwise it will sink. Here the wood will float on water.

The density of a material denotes the measurement which compares the amount of matter an object has to its volume. An object with more matter in a certain volume has a high density. It is defined as the mass per unit volume.

The density is usually represented by symbol ρ or by the letter D. The formula used to calculate the density is:

Density = Mass / Volume

D = 100 / 300 = 0.33 g/cm³

Here the density of water is 1.0 g/cm³ which is greater than the density of  pine wood. So the pine wood will float on water.

To know more about density, visit;

https://brainly.com/question/29775886

#SPJ2

The pH of a 0.50M solution of malic acid with ka1 = 4. 0 × 10-⁴ and ka2 = 6. 3 × 10-⁶ as described is; 1.85.

Since, in a polyprotic acid the first hydrogen will dissociate faster than the others, If the Ka values differ by a factor of 10-³ or more, it is possible to approximately calculate the pH by using only the Ka of the first hydrogen ion.

However, the situation is different in this scenario.

On this note, the solution is as in the attached image.

Read more on Diprotic acids;

https://brainly.com/question/26015203

The pH of a 0.50 m solution of malic acid is 1.85.

pH is potential hydrogen. It is the measurement of the acidity and basicity of any solution.

The ka1 = 4. 0 × 10⁻⁴

The  ka2 = 6. 3 × 10⁻⁶

The solution is 0.50 m.

First calculate the ka value

[tex]ka = \dfrac{x^2}{0.50} \\\\x^2 = 0.50 \times 4 \times 10^-^4\\\\x^2 = 2 \times 10^-^4\\x^2 = \sqrt{2 \times 10^-^4} \\\\ x = [H^+] = 1.41 \times 10^-^2[/tex]

Now, calculate the pH

[tex]pH = -log [H^+]\\\\pH = -log[ 1.41 \times 10^-2]\\\\pH = 1.85[/tex]

Thus, the pH of a 0.50 m solution of malic acid is 1.85.

Learn more about pH

https://brainly.com/question/15289741

#SPJ4

For all the reactions listed, the moles of products and limiting reactants are;

1. Molar cofficient - 6, oxygen is the limiting reactant

2. Molar coefficient - 8 chlorine is the limiting reactant

3. Molar coefficient - 4 and CO2 is the limiting reactant

A chemical reaction is a combination of reactants that yields products. Recall that the limiting reactant is the reactant that nis present in the least amount.

Let us now complete each reaction;

1. The molar coefficient of the product in reaction 1 is 6 and oxygen is the limiting reactant

2. The molar For all the reactions listed coefficent of the product in reaction 2 is 8 and chlorine is the limiting reactant

3. The molar coefficient of the product in reaction 3 is 4 and the limiting reactant is CO2.

Learn more about limiting reactant: https://brainly.com/question/14225536

The mass of nickel, Ni deposited when 0.2 faraday of electrical charge is passed through a solution of NiSO₄ is 5.9 g

Ni²⁺ + 2e —> Ni

Molar mass of Ni = 59 g/mol

Mass of Ni from the balanced equation = 1 × 59 = 59 g

Number of faraday = 2

SUMMARY

From the balanced equation above,

2 faraday deposited 59 g of Nickel

From the balanced equation above,

2 faraday deposited 59 g of Nickel

Therefore,

0.2 faraday will deposit = (0.2 × 59) / 2 = 5.9 g of Nickel

Thus, 5.9 g of Nickel were deposited in the process

Learn more about Faraday's law:

https://brainly.com/question/24795850

Answer:

5.9 grams

Explanation:

You need 2 faraday to deposit 1 mole of Ni (59 grams) because there are 2 moles of electrons in equation:

Ni+2 + 2e- --> Ni(s)

So, 0.2 faraday will deposit 1/10 of that or 5.9 grams of Ni(s).

Answer:

Single replacement is a reaction in which one element reacts with another compund to form another compound and another element.

planation:

If the reaction is double displacement then two molecules will be displaced and if it is single displacement reaction then only one element displaces.

Displacement reactions are those reactions in which any element of the given reactant will be displaced by any another element.

If only one element from the reactant molecules will displace then it will be known as single displacement reaction. If two elements or atoms will be displaced from the reactant molecules then it will be known as double displacement reaction.

Hence if one element displaceed then called the single displacement reaction and if two elements displaces then called as the double displacement reaction.

To know more about displacement reactions, visit the below link:

https://brainly.com/question/13328989

Answer:

a grassy meadow

Explanation:

goo

duh

Answer:

Well, if you live on a farm, you have to feed the living animals and when you eat, you use a fork, knife, napkin, chair and those are all nonliving.

Explanation:

Also, if your trying to go on a scavanger hunt, and you pick up an animal then you are  interacting with a living resource. Also water can be counted as both because water isnt alive but it can be used on living things. like if you were to drink it or water the plants.

Answer:

I use plant and dog as living things and mobile and dish as non living things everyday.

Explanation:

I use plants to get oxygen, vegetables and herbs and dog to help me to protect my home everyday. similarly, I use mobile to call others and I use dish to eat food everyday.

A double displacement reaction is a type of reaction in which two reactants exchange ions to form two new compounds. Many double displacement reactions occur between ionic compounds that are dissolved in water. A double replacement reaction is represented by the general equation.