Answer:
Ground state means when n = 1
and here the electronic configuration is 2:8:2
what mass of carbon dioxide is produced from combustion of 100.0 grams of propane (C^3H^8)
Answer:
Mass of CO₂ produced = 299.64 g
Explanation:
Given data:
Mass of CO₂ produced = ?
Mass of propane (C₃H₈) = 100.0 g
Solution:
Chemical equation:
C₃H₈ + 5O₂ → 3CO₂ + 4H₂O
Number of moles of propane:
Number of moles = mass/molar mass
Number of moles = 100.0 g/ 44.1 g/mol
Number of moles = 2.27 mol
Now we will compare the moles of propane and carbon dioxide.
C₃H₈ : CO₂
1 : 3
2.27 : 3/1×2.27 = 6.81 mol
Mass of CO₂:
Mass = number of moles × molar mass
Mass = 6.81 mol × 44 g/mol
Mass = 299.64 g
What conversion factors
determine the number of
molecules from the mass of a
compound?
Answer: Multiply the mass by the inverse of molar mass, and then multiply by Avogadro's number.
Explanation: Convert the mass to moles, multiply the number of moles by the ratio of the number of atoms or ions to one mole, multiply by Avogadro's number.
Select the correct answer from each drop-down menu.
Researchers stationed at different areas on a mountain and in a tunnel midway through the mountain boiled water at the same time. Even though the water at every station was at the same temperature, the pot at the top of the mountain started boiling before the others. Why?
Water boils when the vapor pressure is
the atmospheric pressure. The atmospheric pressure
at the top of the mountain.
Water boils when the vapour pressure is least the atmospheric pressure.
The atmospheric pressure is equal at the top of the mountain.
What is atmospheric pressure?The air around you has weight, and it presses against everything it touches. That pressure is called atmospheric pressure, or air pressure. It is the force exerted on a surface by the air above it as gravity pulls it to Earth.
As we go up in altitude the air pressure becomes less. When the pressure decreases, it takes less energy to get the water molecules to escape the surface. So the temperature is less than it would be at sea level.
Air pressure is higher or greater at the bottom of a mountain. This is because the height of the air above that level is thicker than at the top.
Pressure is given by the equation, P=rho*g*h, where rho is the air density, g is the gravity value and h is the thickness of the air layer on top of the level where we are considering the pressure.
Therefore, as we can see, at the bottom of the mountain, the thickness h of air is greater, and so is the pressure.
Hence, water boils when the vapour pressure is least the atmospheric pressure and the atmospheric pressure is equal at the top of the mountain.
Learn more about the atmospheric pressure here:
https://brainly.com/question/11484577
#SPJ2
PLZ HELP!
Why do we use ramps (inclined planes) to help us move objects?
Plz nothing from the internet :D
Our Sun will eventually turn into a red giant and, finally, a white dwarf. Use the Hertzsprung-Russell
diagram to describe how the Sun's luminosity and temperature will change as it goes through these
stages.
Our Sun will eventually turn into a red giant in the cooler temperature and high luminosity and in the white dwarf phase has a hot temperature & dim luminosity.
What is Hertzsprung-Russell diagram?In astronomy, the Hertzsprung-Russell diagram, often known as the H-R diagram, is a graph that plots the absolute magnitudes (intrinsic brightness) of stars against their spectral classifications (temperatures).
From the given diagram it is clear that when sun turns into a red giant then the temperature decreases and luminosity increases as it becomes large in size. And when it finally become a white dwarf then temperature comparatively increases and luminosity gets dim due to smaller size.
Hence in the red giant phase sun has a cooler temperature and high luminosity and in the white dwarf phase has a hot temperature & dim luminosity.
To know more about Hertzsprung-Russell diagram, visit the below link:
https://brainly.com/question/22641110
#SPJ2
How many molecules of nitrogen dioxide NO2 are in 1 mole of NO2?
Answer:
The answer is 46.0055. We assume you are converting between grams NO2 and mole. You can view more details on each measurement unit: molecular weight of NO2 or mol This compound is also known as Nitrogen Dioxide.
Explanation:
hope this helps
0.00099989
3 sig figs, scientific notation
Calculate the volume, in liters, occupied by 1.80 moles of H2 gas at STP.
Answer:
40.32L
Explanation:
So we know that 22.4 Liters is one mole of a gass so we can set up an equation to test that
1mole 1.8mole
_____ = _____
22.4L x
and then cross multiply so you get 40.32L
Answer:
40.32L
Explanation:
Just did worksheet
Which is the balanced equation for S8 + O2 → SO2?
S8 + O16 → 8SO2
S8 + O2 → S8 + O2
S8 + O2 → S8O2
S8 + 8O2 → 8SO2
Answer: S8 + O2 → S8O2: not 100% sure
Explanation:
A balanced chemical equation happens when the quantity of the particles is required on the reactants side is equivalent to the quantity is the molecules in the items side.
PLEASE HURRY
Which layer of Earth is the densest and why is that so?
A: The outer core is densest due to gravitational compression.
B: The outer core is densest due to generation of radiogenic heat.
C: The outer core is densest due to accretion.
C: The inner core is densest due to gravitational compression.
D: The inner core is densest due to generation of radiogenic heat.
Answer:
D
Explanation:
Answer: C: The inner core is densest due to gravitational compression
Explanation:
A sample of gas has a volume of 20.0 mL at STP. What will the volume be if the temperature is changed to 546 K and the pressure is changed to 2.0 atm.? (show work plz)
The volume did not change, it remained at 20 ml
Further explanationGiven
20 ml a sample gas at STP(273 K, 1 atm)
T₂=546 K
P₂=2 atm
Required
The volume
Solution
Combined gas Law :
[tex]\tt \dfrac{P_1.V_1}{T_1}=\dfrac{P_2.V_2}{T_2}[/tex]
Input the value :
[tex]\tt \dfrac{1\times 20}{273}=\dfrac{2\times V_2}{546}\\\\V_2=\dfrac{1\times 20\times 546}{273\times 2}\\\\V_2=20~ml[/tex]
The volume does not change because the pressure and temperature are increased by the same ratio as the initial conditions (to 2x)
The prefix "semi-" means "partly". Based on your knowledge of the properties of elements, which kind of element is most likely used to make semiconductors?
liquids
metalloids
metals
nonmetals
Answer:
metalloids
Explanation:
The kind of element most likely used to make semiconductors are the metalloids.
These elements have properties between those of metals and non-metals in that they are not truly metals and are partly non-metals.
Under certain conditions they show features of metals or non - metals. The class of these elements are the metalloids. They are used to make semiconductors which are major components of electronics.What is the pH of a 0.00001 M solution of HCI?
Answer:
0.00001= 1 x 10^-5. Since HCl is an acid, 1 x10^-5 is the H+ concentration. Write only the number of the exponent. Therefore, pH = 5.
What is chemical structure about?
Answer:
chemical structure determines the molecular geometry of ca compound by prtraying the arrangement of atoms and chemical bonds in the molecule..
Explanation:
hope this helps any <3
do pressure and temputer remain consant in earth interior
Answer:
no
Explanation:
what the correct answer
Answer:
Alkali metals are elements found in group 1 of the Periodic Table. Alkali metals are soft, malleable, ductile, and are good conductors of heat and electricity. They have low melting and boiling points compared to most other metals.
I have no idea what the answer is
ill guess c
Explanation:
g
(QUICK PLEASE!)
When you walk, your foot pushes down on the ground. What is the response of the ground?
Nothing?
It holds your foot?
It pushes with equal force on your foot?
It pushes with more force against your foot.
Answer:
It pushes back with equal force.
Explanation:
This is pretty much newton's first law.
What is the density of an object with a mass of 125 g and a volume of 150 mL ?
Answer:
13
Explanation:
234567877
How do we know that caramelizing sugar is a chemical change?
It involves dissolving sugar in water.
It changes the state of sugar from a solid to a liquid.
It separates sugar fromn a sugar solution.
It changes the sugar's color.
Answer:
Chemical reaction, a process in which one or more substances, the reactants, are converted to one or more different substances, the products. Substances are either chemical elements or compounds. A chemical reaction rearranges the constituent atoms of the reactants to create different substances as products.
Explanation:
caramel is the product of the sugar and hot water
Answer:
D It changes the sugars color
Explanation:
Because the change of color is a chemical change.
Have a splendid day! I hope you like the answer given.
Iron-containing minerals in rocks may combine with water and air to create rust. This is an example of
A. chemical weathering
B. mechanical weathering
C. abrasion
D. exfoliation
Answer:
A
Explanation:
chemical reaction are those type of reaction that are irreversible and a new substance is being formed therefore when the iron combine with water and air it leads to rusting.
How many hydrogen atoms Is needed for C4H8 to become saturated
Answer:
2 atoms
Explanation:
Because it contain one double bond
DUE VERY VERY VERY SOON
What are the rows of elements called on the periodic table?
Answer:
"The elements are arranged in seven horizontal rows, called periods or series, and 18 vertical columns, called groups."
Explanation:
I GIVE OUT FREE POINTS
it takes a slug 20 minutes to travel from the grass to the trash can a trip of 15 meters. how far could the slug travel in 60 minutes
Answer:
45 meters
Explanation:
Did the math
Are assorted jelly beans heterogeneous or homogeneous
Heterogeneous, which means that they are not evenly combined.
Please help... giving a lot of points and awarding brainliest.
What is the percent of Nitrogen in NH3?
Answer:
82.244%
Explanation:
The mass percent is an important method which is used to calculate the concentration of a solution. The mass percent of nitrogen in NH₃ is 82.2%.
What is mass percentage?The mass percentage of a particular component in a compound can be defined as the ratio of the mass of the particular component to the total mass of the compound.
The equation which is used to calculate the mass percentage is:
Mass percentage = Mass of the component / Total mass of the compound × 100
or
The mass percentage is also calculated as:
% Mass = Mass fraction × 100
Here the mass of 'N' = 14.00 g
The molar mass of NH₃ = 17.031 g/mol
% Mass of 'N' = 14.00 / 17.031 = 0.82
0.82 × 100 = 82.2 %
Thus the mass percentage of nitrogen is 82.2 %.
To know more about mass percentage, visit;
https://brainly.com/question/27429978
#SPJ7
In Step 5, you will calculate H+/OH– ratios for more extreme pH solutions. Find the concentration of H+ ions to OH– ions listed in Table B of your Student Guide for a solution at a pH = 2. Then divide the H+ concentration by the OH– concentration. Record these concentrations and ratio in Table C. What is the concentration of H+ ions at a pH = 2? mol/L What is the concentration of OH– ions at a pH = 2? mol/L What is the ratio of H+ ions to OH– ions at a pH = 2? : 1
The ratio of H⁺ ions to OH⁻ ions at a pH = 2 is 10¹⁰
Further explanationGiven
ph = 2
Required
The concentration of H⁺ and OH⁻ ions
Solution
The concentration of H⁺ ionspH=-log[H⁺]
2=-log[H⁺]
[H⁺]=10⁻²
The concentration of OH⁻ ionspH+pOH=14
pOH=14-2
pOH=12
pOH=-log[OH⁻]
12=-log[OH⁻]
[OH⁻]=10⁻¹²
The ratio of H⁺ ions to OH⁻ ions at a pH = 2[tex]\tt \dfrac{10^{-2}}{10^{-12}}=10^{10}[/tex]
Answer:
First one: 0.01
second one: 0.000000000001
third one: 10000000000
why is magneisum a metal
Answer:
Chemical element, metallic, symbol Mg, situated in group IIa in the periodic table, atomic number: 12, atomic weight: 24,312. ... Magnesium is known for a long time as the lighter structural metal in the industry, due to it's low weight and to it's capability of forming mechanically resistant alloys.
Explain the process of ionic bond formation between K
(potassium, a metal) and Br (bromine, a nonmetal).
I
Answer:
Metals transfers electrons to nonmetals. So K transfers one electron to Br because K is located at 1A in the periodic table. Br has seven electrons, now both K and Br are stable by gaining and losing one electron. The transfer of electrons makes metals to become positive ions and nonmetal to become negative ions. When an ionic bond is formed, the charges attract each other.
Answer: Metals transfers electrons to nonmetals. Potassium -K transfers one electron to bromine- Br because K is located in group 1A on periodic table. Br has seven electrons and located group 7A. Both K and Br stable by gaining and losing one electron. The transfer of electrons makes metals to become + positive ions and nonmetal to become - negative ions. An ionic bond is formed, the charges attract each other.
Explanation: Metals donate, or transfer, electrons to the nonmetal.
The transfer of electrons creates a positive ion and a negative ion.
An ionic bond is formed when the charges attract each other.