which of these is an example of point source pollution

First quarter is the phase of the moon would someone on Earth will see  when the moon is at Positions A through F.

This is the phase which occurs when the moon is 90 degrees away from the sun in the sky and is half-illuminated from our point of view.

When looking it at the moon from point F it's half-illuminated which depicts the First quarter moon phase.

Read more about First Quarter of moon here https://brainly.com/question/13538936

Answer:

14,400

Explanation:

I guessed and I think it's right Soo

Answer:

This is your answer

If I freeze fresh water and salt water then the fresh water will freeze more quickly because salt lowers the freezing point temperature

Explanation:

I hope it helped you

For an automobile spring using a 25 kg car battery, the spring constant is mathematically given as

K=4.08.3N/m

Question Parameter(s):

a 25 kg car battery

The springs are pulled out by 0.06 meters

Generally, the equation for the Force  is mathematically given as

F=mg

Therefore

F=(25*9.8)

(25*9.8)=K(0.06)

K=4.08.3N/m

In conclusion, the spring constant

K=4.08.3N/m

Read more about Force

https://brainly.com/question/13370981

Answer:

I = Q / t          definition of current I

Q = i t = 10 Coul/sec * 60 sec = 600 Coul

A 10-A current is maintained in a simple circuit with a total resistance of 209 ohms, then the net charge passes through any point in a circuit during a 1-minute interval would be 6000 Coulombs.

Charged material experiences a force when it is exposed to an electromagnetic field due to the physical property of electric charge. You can have a positive or negative electric charge.

Electric current is defined as the charge per unit of time.

The mathematical relation between current and the electric charge

I =Q/T

Let us first convert the time period of minutes into seconds

1 min = 60 seconds

10  min = 10*60 seconds

            =600 seconds

Q = I*t

   =10*600

   =6000 Amperes

Thus, the net charge that passes through any point in a circuit during a 1-minute interval would be 6000 Amperes.

To earn more about an electric charge from here, refer to the link;

brainly.com/question/8163163

#SPJ2

Answer:

0.03 m/s

Explanation:

Applying law of conservation of momentum,

The best answer is true. Yes, control rods are used to slow down the reaction in the reactor core when the core becomes too hot.

A nuclear reactor, often known as an atomic pile, is a device that initiates and controls nuclear chain reactions or nuclear fusion processes.

Nuclear reactors are used in nuclear power plants to generate energy as well as in nuclear marine propulsion.

Control rods are employed in nuclear reactors because the processes that occur in a nuclear reactor are very exothermic.

As a result, when these control rods are infused into a nuclear reactor, they absorb neutrons and aid in the management of the chain reaction. As a result, the rate of the chain reaction is brought under control.

As a result, we may infer that the statement control rods are employed to slow down the reaction in the reactor core when it gets too hot is correct.

Hence the best answer is true. Yes, control rods are used to slow down the reaction in the reactor core when the core becomes too hot.

To learn more about the nuclear reactor refer to the link;

https://brainly.com/question/896706

The visible spectrum is composed of red, orange,yellow,  green, blue, violet, indigo.

The visible spectrum refers to the portion of the electromagnetic spectrum that can be seen with the eyes. All other portions of the electromagnetic spectrum are invisible.

The question is incomplete as the details are missing. The visible spectrum is composed of red, orange,yellow,  green, blue, violet, indigo.

Learn more about the visble spectrum: https://brainly.com/question/1596783

Answer:

We stay hugely we devour

Explanation:

It's the rock

Seismic waves do not travel along the Earth’s surface. The statement is false.

The seismic waves can be defined as the waves full of energy that travel through the Earth's layer, these waves are the result of earthquake.

They can further be divided into two types body wave and surface waves. The body waves travel in the interior of the Earth and the surface waves travel at the surface of the Earth.

The seismic waves can have an amplitude of few centimeters in large earthquake. They travel slower as compared to the body waves.

Hence Seismic waves do not travel along the Earth’s surface. The statement is false.

To know more about Seismic waves follow

https://brainly.com/question/6835759

Answer:

False

Explanation:

Ed 2022

Explanation:

it is not clear. I can't see w.

Advandages:

1. Every unit that is connected in a parallel circuit gets equal amount of voltage.

2. It becomes easy to connect or disconnect a new element without affecting the working of other elements.

3. If any fault happened to the circuit, then also the current is able to pass through the circuit through different paths.

Disadvantages:

1. It requires the use of lot of wires.

2. We cannot increase or multiply the voltage in a parallel circuit.

3. Parallel connection fails at the time when it is required to pass exactly same amount of current through the units.

The net torque on this system is (ml2g-ml1g)k

This refers to the type of force that causes rotation in objects which has mass and is a twisting force

Based on the complete question, we can see the given parameters:

The torque due to farther mass above the pivot is ml2gk

The torque due to nearer mass about the pivot is ml1gk

Therefore, the net torque is (ml2g-ml1g)k

Read more about torque here:
https://brainly.com/question/14839816

The net torque on this system in which two blocks each of mass m are attached to the ends of a massless rod, above pivot, is (ml₂g-ml_₁g)\hat k.

The torque of a body is the rate of change of angular momentum of the body. Torque is the product of moment of inertia and the angular acceleration.[tex]\tau =I\times \alpha[/tex][tex]\tau=mlg[/tex]

Here, (I) is the moment of inertia and (α) is the angular acceleration.

Two blocks each of the mass m are attached to the ends of a massless rod which pivots as shown in fig.

Initially, the rod is held in the horizontal position and then released. When, the mass was kept at farther to pivot, then the value of torque is,

[tex]\tau=ml_2g\hat k[/tex]

When, the mass was kept at nearer to pivot, then the value of torque is,

[tex]\tau=-ml_1g\hat k[/tex]

Thus, the net torque on this system above pivot is,

[tex]\tau=ml_2g\hat k+(-ml_2g\hat k)\\\tau=(ml_2g-ml_1g)\hat k[/tex]

Thus, the net torque on this system in which two blocks each of mass m are attached to the ends of a massless rod, above pivot is (ml₂g-ml_₁g)\hat k.

Learn more about the torque here;

https://brainly.com/question/25482609

#SPJ4

Answer:

Barium nitrate

[tex] \sf \qquad \qquad \huge \underbrace{єхplαnαtiσn}[/tex]

The correct choice is ❝ A ❞

❖ whєn wє tαlk αвσut α pєndulum, ít gσєѕ thrσugh ❝ tσ αnd frσ ❞ mσtíσn, αlѕσ knσwn αѕ hαrmσníc mσtíσn. αѕ вєíng ín thє cαѕє σf α pєndulum, thєrє'ѕ α cσntínuσuѕ chαngє ín kínєtíc αnd pσtєntíαl єnєrgч.

❖ whєn thє вσв íѕ αt mєαn pσѕítíσn, ít hαѕ ítѕ mαхímum vєlσcítч, αnd thє nєt fσrcє αnd αccєlєrαtíσn αctíng σn ít íѕ zєrσ, thєrєfσrє ít hαѕ mαхímum kínєtíc єnєrgч αt thαt pαrtículαr ínѕtαnt.

❖ whєrє αѕ, íf thє вσв íѕ αt σnє σf thє єхtrєmє pσѕítíσnѕ, ítѕ vєlσcítч вєcσmєѕ zєrσ, αnd thє αccєlєrαtíσn αnd fσrcє αctíng σn ít íѕ mαхímum, ѕímcє ít hαѕ nσ vєlσcítч, thєrєfσrє ít hαѕ nσ kínєtíc єnєrgч αt thαt ínѕtαnt, thє σnlч єnєrgч ít hαѕ αt thαt tímє íѕ pσtєntíαl єnєrgч.

❖ ѕíncє thє mσvєmєnt íѕ cσntínuσuѕ, cσntínuσuѕ chαngє ín єnєrgч σccurѕ, вut thє ѕum σf вσth thє єnєgíєѕ rєmαínѕ cσnѕtαnt αt єvєrч ínѕtαnt.

[tex]\qquad \qquad\huge \dag\normalsize\sf \boxed{\underline{ǤríʍɌεαƿєr}} \: \huge \dag[/tex]

Answer:

5 ohms

Explanation:

V = IR

10 = 2 R

R = 5

The stopwatch will be the most useful in determining the kinetic energy of a 50 g battery- powered car traveling a distance of 10 m.

Kinetic energy is the energy of a body possessed due to motion.

This means that for an object to possess kinetic energy, it must be in motion.

The kinetic energy is measured in Joules, which is a product of the mass of the substance and the time taken to travel a distance.

A stopwatch is an instrument used to measure time as one of the components of kinetic energy.

Therefore, the stopwatch will be the most useful in determining the kinetic energy of a 50 g battery- powered car traveling a distance of 10 m.

Learn more about kinetic energy at: https://brainly.com/question/12669551

Answer:

the same as the initial launch velocity (7.59 m/s)

Explanation:

vf^2 = vi^2 + 2ad

d = displacement = 0, so vf^2 = vi^2, so vf = vi = 7.59m/s

Answer:

a-d

Explanation:

hope this helps

Answer:

Globular star clusters are located in the great spherical halo.

Explanation:

Hope this helps! :)

Explanation:

What are the integers between -4 and +4?

Answer:

 It increases to three times it's original value.

Explanation:

B

Hi there!

Recall the equation for the magnetic field of a wire (assuming infinite):

[tex]B = \frac{\mu _0 i_{encl}}{2\pi r}[/tex]

B = Magnetic field (T)
μ₀ = Permeability of Free Space (Tm/A)

i = enclosed current (A)
r = distance from wire (m)

From the equation, we can see that there is a DIRECT relationship between the current and the magnetic field.

Therefore, if the current is increased by a factor of 3, the FIELD will also be increased by a factor of three.

Answer:

a

Explanation:

Answer:

its called a fault

Explanation:

Its when u mess up

Answer:

Around 190-ish miles per hour when it hit the ground maybe

Explanation:

Explanation:

Given : m=600kg h=20 m

Time of operation t=2 min =120 s

Work done in lifting a box W=mgh=600×10×20=120000

Power required P=

t

W

=

120

120000

=1000 watts

Answer:

Brainliest pls

Explanation:

lead solder, an alloy of tin and lead

window cleaner, a mixture of ammonia and coloring dissolved in water

gasoline, a mixture of organic liquids with a fixed composition throughout

The solutions and homogeneous mixtures in the given list are:

A. Lead solder, an alloy of tin and lead.

D. Window cleaner, a mixture of ammonia and coloring dissolved in water.

E. Gasoline, a mixture of organic liquids with a fixed composition throughout.

A solution can be defined as a special type of homogeneous mixture that comprises a solute and a solvent.

A homogeneous mixture can be defined as any solid, liquid, or gaseous mixture which has an identical (uniform) composition and properties throughout any given sample of the mixture.

In Science (Physics), all solutions are considered to be a homogeneous mixture because their constituents are uniformly (evenly) distributed.

In conclusion, the solutions and homogeneous mixtures in the given list are:

To know more about solution follow

brainly.com/question/22070951

Answer:

A, B, C, E

Explanation:

Who wants to be shipped out, am I right?

Answer:

It would be equal pay, equal treatment, access to credit

AND access to higher education.

Explanation:

Hope this helps you!!!!

Explanation:

velocity = frequency × wave length

velocity = 440 × 0.78

velocity = 343 m/sec

can you please mark my answer brainliest ♥️