Answer: C
Explanation:
lonic bonds tend to form between two atoms with what characteristics?
Answer:Ionic bonds are formed through the exchange of valence electrons between atoms, typically a metal and a nonmetal. The loss or gain of valence electrons allows ions to obey the octet rule and become more stable. Ionic compounds are typically neutral. Therefore, ions combine in ways that neutralize their charges.
Explanation:
Ionic bonds tend to form between two atoms with a high electronegativity difference.
Explanation:
An Ionic bond is defined as a chemical bond in which the complete transfer of electrons occurs from one atom to another.The transfer of electrons occurs from less electronegative atom to highly electronegative atomThe high electronegativity difference between the atomsCompounds with ionic bonds categorized as ionic compoundsSo, from this, we can conclude that ionic bonds tend to form between two atoms with a high electronegativity difference.
Learn more about ionic compounds here:
brainly.com/question/7193259?referrer=searchResults
brainly.com/question/1669915?referrer=searchResults
Which of these describes a challenge that the engineer of a high-altitude
airplane would need to consider?
A. More fuel is used at higher altitudes.
B. The airplane may succumb to the power of gravity as lift
decreases at higher altitudes.
C. The airplane may need a heat shield for protection from sonic
booms.
O D. The airplane will create more drag at higher altitudes than lower
altitudes.
Answer:
I think its (B)
Explanation:
as when the air thins out at higher elevations, your lift decreases so at some point, the plane cant produce enough lift to overcome gravity.
help pls I will give brainliest!
Answer:
The answer is D, I would type it out but it is to long and I'm kind of lazy, but anyways! Your answer is D
Hope This Helps!
need help asap!!!!
will mark brainliest!!!
We can verify the properties as follows;
1) Sour taste - Put some soda on your tongue
2) Corrode metals - Put a little soda on a clean metal surface
3) Effect on Litmus paper - Dip a blue litmus paper in soda
4) Electrolysis - Add two electrodes to soda and connect a battery.
Does Soda show acidic properties?Soda, specifically carbonated beverages like cola or soda pop, typically exhibits acidic properties. The acidity of soda is primarily due to the presence of carbonic acid (H₂CO₃), which forms when carbon dioxide gas (CO₂) dissolves in water.
When carbon dioxide is dissolved in water under high pressure, it forms carbonic acid through the following reaction:
CO₂ + H₂O ⇌ H₂CO₃
Learn more about Soda:https://brainly.com/question/31889777
#SPJ1
When a solid with a mass of 53.78 g is added to 50.0 ml of water in a graduated cylinder, the volume increases to 56.4 ml. Calculate the density of the solid.
Answer:
The answer is 8.40 g/mLExplanation:
The density of a substance can be found by using the formula
[tex]density = \frac{mass}{volume} \\ [/tex]
volume = final volume of water - initial volume of water
volume = 56.4 - 50 = 6.4 mL
We have
[tex]density = \frac{53.78}{6.4} \\ = 8.403125[/tex]
We have the final answer as
8.40 g/mLHope this helps you
plsssssssssssssssssssssssssssssssssssssssss help me
Answer:
C
Explanation:
A year is a complete revolution around the Earth
which statement is a scientific law
Answer:
It is b
Explanation:
1. Which best represents a compound?
Answer:
D
Explanation:
The one that best represents a compound is answer "D" because you compounds are chemically bonded and are always together.
Clinical thermomerter
Answer:
Here is the definition: A medical thermometer (also called clinical thermometer) is used for measuring human or animal body temperature.
Isopropyl alcohol is a liquid with a density of 0.785 g/cm^3. How much volume would be taken up be 50.0 grams of isopropyl alcohol
Answer:
63.94 cm³Explanation:
The volume of a substance when given the density and mass can be found by using the formula
[tex]volume = \frac{mass}{density} \\ [/tex]
From the question we have
[tex]volume = \frac{50}{0.785} \\ = 63.694267...[/tex]
We have the final answer as
63.94 cm³Hope this helps you
Among the groups of elements listed below, which have the same number of electrons in their outermost energy levels?
O NP. As, Sb
None of these
OK, Ca, Rb, Sr
OLI, B, C F
O Na Mg, ALS
Answer:
N, P, As, Sb
Explanation:
Elements present in the same group having same number of valence electrons. The first option is correct from given options because nitrogen, phosphorus, arsenic and antimony are present in same group thus having same number of electrons in outer most energy level.
Electronic configuration of N:
N₇: [He] 2s² 2p³
Electronic configuration of P:
P₁₅: [Ne] 3s² 3p³
Electronic configuration As:
As₃₃: [Ar] 3d¹⁰ 4s² 4p³
Electronic configuration Sb:
Sb₅₁: [Kr] 4d¹⁰ 5s² 5p³
Here it is clear from electronic configuration all these elements have five number of valence electrons.
The half-life of carbon-14 is about ____________ years.
Fill in the blank.
Answer:
5730 years
Explanation: for more on radiocarbon dating.) and hence explain why the amount of carbon-14 in the sample decays by half over any period of 5730 years.
You can see protons yes or no
No. Not with the naked eye
Carbon dioxide is formed by the given formula.
C(s)+O2(g)→CO2(g)
Carbon dioxide is
A
a compound of two elements, carbon and oxygen.
B
a mixture of two compounds, carbon and oxygen.
C
a compound of two atoms, carbon and oxygen.
D
an element of two atoms, carbon and oxygen.
Answer:
A
Explanation:
What does an atomic number represent in an atom? number of neutrons number of protons number of electrons number of protons and neutrons
Answer:
The number of protons in the nucleus of the atom is equal to the atomic number (Z). The number of electrons in a neutral atom is equal to the number of protons. The mass number of the atom (M) is equal to the sum of the number of protons and neutrons in the nucleus.
Answer: I'm pretty sure the answer is Number of Protons
Explanation:
I took the k-12 test
please help this is worth half of my grade! what letter represents the trough of the wave a,b,c,d,e
Hello good afternoon...God bless the answer to your following question is D
because...A crest point on a wave is the maximum value of upward displacement within a cycle. A crest is a point on a surface wave where the displacement of the medium is at a maximum. A trough is the opposite of a crest, so the minimum or lowest point in a cycle.
Who knows the answer to this please help
I NEED HELP!!
In a stream, how are particles such as silt, clay, and sand carried?
A. as dissolve load
B. as bed load
C. in suspension
D. in solution
In a stream, how are particles such as silt, clay, and sand carried?
A. particles rubbing together
B. An increase is suspended materials
C. an increase in the dissolve load
D. changes in the stream 's carrying capacity
The path of a stream can vary considerably, depending on the slope of the land and the
A. bedload of the stream
B. amount of rainfall
C. amount of hummus present in the soil
D. Type of material through which the stream flows
The amount of dissolved material that stream water carries is usually expressed in
A. cubic meters per second
B. parts per million
C. cubic feet per minute
D. grams per 1000 gallons
The carrying capacity of a stream depends on both the velocity and the
A. Temperature of the water
B. amount of water in the stream
C. type of material through which the stream flows
D. minerals dissolved in the stream
Answer:
1 B
2A
#D
3B
1D
2B
3C
4A
A,C,A,B
C,A,C,A
C,A,A,B
Explanation:
Easy ive done this brings back memories
In ecosystem, particles are carried as bed load by rubbing particles together.Path of stream can be varied depending on amount of humus present in soil and is measured in cubic meters per second and carrying capacity depends on type of material through which stream flows.
What is an ecosystem?Ecosystem is defined as a system which consists of all living organisms and the physical components with which the living beings interact. The abiotic and biotic components are linked to each other through nutrient cycles and flow of energy.
Energy enters the system through the process of photosynthesis .Animals play an important role in transfer of energy as they feed on each other.As a result of this transfer of matter and energy takes place through the system .Living organisms also influence the quantity of biomass present.By decomposition of dead plants and animals by microbes nutrients are released back in to the soil.
Learn more about ecosystem,here:
https://brainly.com/question/1673533
#SPJ2
Look at the chemical equation below.
2N2 + O2 2N2O
How many Nitrogen molecules are present? ___________
How many Oxygen molecules are present? ___________
How many N2O molecules are present? ___________
The molecules of Nitrogen, oxygen, and N₂O are 2, 1, and 2 respectively.
What is the chemical equation?A chemical equation can be defined as the expression of a chemical reaction in terms of the chemical symbols of the substances. A chemical equation has reactants, formed products, and an arrow indicating the direction of the reaction.
The equation in which the number of atoms of each element is equal on either side of the chemical equation of a reaction is called a balanced chemical equation.
According to the law of mass conservation, the total mass of the elements on the reactant side should be equal to the total mass of elements on the product side.
Given, the chemical equation of the reaction of nitrogen ad oxygen gas can be written as:
2N₂ + O₂ → 2N₂O
The number of molecules of Nitrogen gas is 2 and the molecules of oxygen gas are one and the molecules of N₂O are equal to 2.
Learn more about the chemical equation, here:
brainly.com/question/28294176
#SPJ3
A block of lead displaces 50.5ml of water. The block weighs 698 g. From this
information, calculate the density of lead.
Answer:
13.82 g/mLExplanation:
The density of a substance can be found by using the formula
[tex]density = \frac{mass}{volume} \\ [/tex]
From the question we have
[tex]density = \frac{698}{50.5} \\ = 13.8217...[/tex]
We have the final answer as
13.82 g/mLHope this helps you
Which of the following are electromagnetic waves? *
Water waves
Sound waves
Radio waves
Seismic waves
A given mass of gas in a rigid container is heated from 100 °C to 300 °C. Which of the following best describes what will happen to the pressure of the gas? The pressure will
Taking into account the Gay-Lussac's Law, the pressure will increase by a factor less than three.
Gay-Lussac's law indicates that, as long as the volume of the container containing the gas is constant, as the temperature increases, the gas molecules move faster. Then the number of collisions against the walls increases, that is, the pressure increases. That is, the pressure of the gas is directly proportional to its temperature.
In summary, when there is a constant volume, as the temperature increases, the pressure of the gas increases. And when the temperature is decreased, the pressure of the gas decreases.
Mathematically, Gay-Lussac's law indicates that the ratio of pressure to temperature is constant:
[tex]\frac{P}{T} =k[/tex]
Studying two different states, an initial state 1 and a final state 2, it is satisfied:
[tex]\frac{P1}{T1} =\frac{P2}{T2}[/tex]
In this case, a given mass of gas in a rigid container is heated from 100 ° C to 300 ° C, that is, it is heated from 373 ° K to 573 ° K. This indicates that the temperature is increasing by a factor less than three. Since pressure is directly proportional to temperature, pressure must increase in the same proportion.
Finally, the pressure will increase by a factor less than three.
Learn more:
https://brainly.com/question/4147359?referrer=searchResultsWhat effect does the spinning of the earth's core have?
A.it creates gravity
B. it creates matter
C. it creates mass
D. it creates the earths magnetic field.
Answer:
c
Explanation:
its c
Earth contains a spinning electric filed. The spinning of earth core creates its magnetic field. Thus, option D is correct.
What is a spinning body?A body which rotates in its own axis is called a spinning body. Earth rotates about its along with revolving around sun. The outer core of earth generates electric current. This is called telluric current.
Flow of this current creates an electric current which is parallels to the surface of earth. The direction of magnetic field lines will be perpendicular to the direction of current. But it comes stronger when parallel to current.
A rotating electric current results in the generation of a magnetic field. Thus spinning of earth core generates a magnetic field and therefore, option D is correct.
To learn more about magnetic field, refer the link below:
https://brainly.com/question/11514007
#SPJ2
I WILL GIVE BRAINLIEST TO YOU IF YOU ANSWER THIS (I KNOW THE ANSWER, SO IF YOU SOLVED WRONG, I WONT GIVE BRAINLIEST) SO YOU BETTER GIVE CORRECT ANSWER OR IM NOT GOING TO GIVE BRAINLIEST
Answer:
Corona Virus outbreak
After pollen lands on the stigma of a flower, which of the following happens first?
Help I will give brainlist
What is an atomic nucleus
Answer:
The atomic nucleus is the small, dense region consisting of protons and net at the center of an atom.
Explanation:
The atomic nucleus is the small, dense region consisting of protons and neutrons at the center of an atom, discovered in 1911 by Ernest Rutherford based on the 1909 Geiger–Marsden gold foil experiment. ... Protons and neutrons are bound together to form a nucleus by the nuclear force.
Answer:
The atomic nucleus is the small , dense region consisting of protons and neutrons at the center of an atom .
Which type of bond is salt? a. covalent b. valence c. metallic d. ionic
Answer:
D. Ionic
Explanation:
It has ionic bonding! Good luck ^^
Select the correct answer
Giving brainliest
Answer:
I'm gonna say A and B
Explanation:
Not sure though
Hope I helped :)
Explain why the Earth has four different seasons
Answer:
Earths rotation
Explanation:
Answer:
because if there was not four diferent season we would not have a day or a night because we would not be moving
Explanation:
Which of the following elements is a metalloid? A. phosphorus B. cobalt C. silicon D. magnesium
Answer: silicon
Explanation:it just is
Respuesta
es la C. silicio
Explanation:
No existe una definición estandarizada de elemento metaloide ni un consenso completo sobre los elementos que son metaloides.
En la clasificación de metaloides se suelen incluir a:
Boro (B)
Silicio (Si)
Germanio (Ge)
Arsénico (As)
Antimonio (Sb)
Telurio (Te)