The distribution coefficient between methylene chloride and water for solute Y is 14. An amount of 72.0 g of Y is dissolved in 180 mL of water. a) What weight of Y would be removed from water with a single extraction with 180-mL of methylene chloride? Report to 1 decimal place. b) What total weight of Y would be removed from water (the original solution) with two successive extractions with 90-mL portions each of methylene chloride?

Answer:

organ system

Explanation:

Answer:

B) organ

Explanation:

Answer:

ARSENIC

Explanation:

It has an atomic number of 33

Answer:

the answer is B

Explanation:

When an atom has an equal number of electrons and protons, it has an equal number of negative electric charges

Moles of [tex]H_2O[/tex] ,

[tex]n_{H_2O}=\dfrac{42}{2\times 1 + 16}=\dfrac{42}{18}\\\\n_{H_2O}=2.33\ moles[/tex]

Moles of acetic acid [tex]HCH_3CO_2[/tex] ,

[tex]n_{A.A}=\dfrac{77}{1 + 12 + 3 + 12 + 16\times 2}=\dfrac{77}{60}\\\\n_{A.A}=1.28\ moles[/tex]

Mole fraction of water :

[tex]M.F_{H_2O}=\dfrac{n_{H_2O}}{n_{H_2O}+n_{A.A}}\\\\M.F_{H_2O}=\dfrac{2.33}{2.33+1.28}\\\\M.F_{H_2O}=0.645[/tex]

Therefore, mole fraction of water in this solution is 0.645 .

Hence, this is the required solution.

Answer:

D

Explanation:

Identifying unique features of evidence

A laboratory is a place where scientific investigations and experiments are conducted. Observing a phenomenon in the lab includes identifying unique features of evidence. Thus, option D is correct.

An observation is said to be the deduction that is seen or heard and is due to the actions of the process or event that are gained from the information from a conducted experiment.

It is an important factor in an experiment and research and is used in the lab to falsify or prove the hypothesis. It is made based on the experimental setup and involves various steps.

The observations are used to draw conclusions and inferences based on the detailed identification of the characteristics of the evidence. The evidence supports the observation.

Therefore, option D. the features of evidence are the correct option.

Learn more about observations here:

https://brainly.com/question/28041973

#SPJ2

Answer:

Changes in environment, food source changes and disease?

Explanation:

I dont know what the answer choices are

Answer:

changes in the environment

Explanation:

like digging big holes.

Hope this helps!

Answer:

See explanation

Explanation:

a) -About 1-2 drops of the unknown is dissolved in approximately 1 mL of analytical grade acetone standard solution. The test solution is added and shaken thoroughly.  If a positive test is not immediately observed, the set should be allowed to stand for 1-2 minutes. A positive result means the appearance of a green color.

b) The functional groups that can be distinguished by the test are alcohols and aldehydes.

Aldehydes give a positive test to chromic acid but ketones do not.

Primary and secondary alcohols give a positive test to chromic acid but tertiary alcohols do not.

c) Chromic Acid Test involves Cr in the +6 oxidation state. A positive test implies the reduction of orange Cr^6+ to green chromium Cr^3+.

d) The compounds were not shown but this image attached from lumen learning summarizes the reaction mechanism of chromic acid test.

Answer:

Final volume  = 0.44 L

Explanation:

Given data:

Initial volume of balloon = 1.1 L

Initial pressure = 0.80 atm

Final volume = ?

Final pressure = 2.0 atm

Solution:

The given problem will be solved through the Boly's law,

"The volume of given amount of gas is inversely proportional to its pressure by keeping the temperature and number of moles constant"

Mathematical expression:

P₁V₁ = P₂V₂

P₁ = Initial pressure

V₁ = initial volume

P₂ = final pressure

V₂ = final volume  

Now we will put the values in formula,

P₁V₁ = P₂V₂

0.80 atm × 1.1 L = 2.0 atm × V₂

V₂ = 0.88 atm. L/ 2.0 atm

V₂ = 0.44 L

Answer:

Explanation:

Since the student fills up the buret with NaOH without rinsing it with small amount of NaOH , the water that is remaining stuck with the walls of the buret will dilute the solution of NaOH and it will result in lowering the morality of the solution . The molar concentration of the NaOH will no longer remain the same . It will lead to wrong calculation and hence wrong result.

The washing of burette in titration with NaOH solution results in the maintaining the concentration of the NaOH in the solution and allows the correct calculation of the molarity.

The titration has been the reaction of the acid with the base resulted in the formation of salt and water and had the neutralization reaction.

The molarity of the base has been used in the analysis of the acid concentration on the neutralization reaction.

The skipping of the step of washing with NaOH resulted in the altering in the concentration of the NaOH with the stuck water on the walls of the burette, and thereby resulted in wrong calculation.

Learn more about titration, here:

https://brainly.com/question/24704707

Answer:

The answer is actually 3. The disorder of a system.

Answer:

make an observation that describes a problem

Explanation:

Answer:

The first step in the Scientific Method is to make objective observations.

Explanation:

....-

Answer:

The Answer is eight.

Explanation:

Sorry if it's too late and it doesn't help! But I hope you have a magnificent day! :3

Answer:

8

Explanation:

I had this question on my quiz and got it right.

Answer:

1.14 M

Explanation:

Let's consider the following reaction.

butane ⇄ isobutane

We can use the concentrations at equilibrium to calculate the equilibrium constant.

Kc = [isobutane] / [butane]

Kc = 2.5 / 1.0

Kc = 2.5

If we add 0.50 M of isobutane, we get [isobutane] = 2.5 + 0.50 = 3.0 M.

This will be an initial concentration in an ICE chart.

        butane ⇄ isobutane

I           1.0              3.0

C         +x                -x

E        1.0+x           3.0-x

The equilibrium constant is:

Kc = 2.5 = [isobutane] / [butane]

2.5 = (3.0-x) / (1.0+x)

2.5 + 2.5x = 3.0-x

x = 0.14

The equilibrium concentration of butane is:

[butane] = 1.0+x = 1.14 M

Answer:

[tex]0.326\frac{N}{cm^2}[/tex]

Explanation:

Hello.

In this case, considering that 1 atm equals 1.01 kPa, we can compute the pressure in kPa first as shown below:

[tex]2.25atm*\frac{1.01kPa}{1atm} =3.26kPa[/tex]

Now, we convert kPa to Pa, considering 1 kPa equals 1000 Pa:

[tex]3.26kPa*\frac{1000Pa}{1kPa}=3260Pa[/tex]

Now, since Pa is equal to N/m², and 1 m equals 100 cm, the pressure in newton per square centimeter turns out:

[tex]3260\frac{N}{m^2}*(\frac{1m}{100cm})^2 \\\\0.326\frac{N}{cm^2}[/tex]

Best regards.

Answer:

d. Pergoldic acid

Explanation:

chlorate = ClO₃⁻

Goldate GoO₃⁻

On this basis we can infer that HClO₄ and HGoO₄ will be similar .

HClO₄ is called perchloric acid , hence HGoO₄ will be called pergoldic acid.

Answer:

C) F

Explanation:

Valence electrons are the electrons present in the outermost shell of an atom and have the highest energy level of an atom whereas electrons at ground state or lower orbitals have less potential energy.

This is so because orbitals nearby nucleus are strongly bonded with the atomic nucleus and have less energy than an outermost shell.

So, the potential energy states of an atom depend on the number of orbitals. In the given options fluorine with atomic number 9 has less number of orbitals that is 2 orbitals and valence electrons will be present in second orbitals, so fluorine will have the lowest average potential energy states.

Hence, the correct option is "C) F".

Ions can be made by single element or covalently bonded group of elements. The covalently bonded group of elements is called polyatomic ions or polyatomic atoms. In order to form an ion, a Group 2 element will loose two electrons and form a cation.

Any species that contain charge whether it is positive charge or negative charge is called ions. The example of polyatomic ions are sulfate, phosphate, nitrate etc.

Cation is the species that loose electron and attain positive charge while anion is a species which gain electron and attains negative charge so when anion and cation combine in fixed ration the the overall charge of the molecule is zero that is molecule is neutral, the charge over cation and anion is also called oxidation state.  In order to form an ion, a Group 2 element will loose two electrons and form a cation.

Therefore, in order to form an ion, a Group 2 element will

loose two electrons and form a cation.

To learn more about ions, here:

https://brainly.com/question/13692734

#SPJ2

Answer:..

Explanation:

Answer:

100 joules​

Explanation:

The mechanical energy (M.E) of an object describes the objects ability to do work. The mechanical energy encompasses the object's energy due to its position (potential energy) and its energy due to motion (kinetic energy).

Therefore,

M.E = K.E + P.E

According to this question, potential energy (P.E) of the roller coaster is 50J and the kinetic energy (K.E) is also 50J. Hence, the mechanical energy (M.E) is

M.E = 50J + 50J

M.E = 100J

If the P.E and K.E of a roller coaster is 50 Joules respectively, the mechanical energy of the roller coaster is 100 Joules.

Given the following data:

To find the mechanical energy of the roller coaster:

The mechanical energy of a physical object or body is the total sum of the potential energy (P.E) and kinetic energy (K.E) possessed by an object.

Mathematically, mechanical energy is given by the formula;

Substituting the given parameters into the formula, we have;

[tex]M.E = 50 + 50[/tex]

Mechanical energy (M.E) = 100 Joules.

Therefore, the mechanical energy of the roller coaster is 100 Joules.

Read more: https://brainly.com/question/23153766

Answer:

True

Explanation:

According to some calculations, the Earth is losing 50,000 metric tons of mass every single year, even though an extra 40,000 metric tons of space dust converge onto the Earth's gravity well, it's still losing weight.

Answer:

true

Explanation:

Answer:

gill lamellae

Explanation:

Gills  in fishes are structures that permit fish to carry out gaseous exchange in water.  Fishes exchange gases  such as oxygen and carbon dioxide using gills.

Fish gills carry out their activity mainly through its major component called the  gill lamellae. These are comb-like filaments which help increase the surface area of the gills in order to facilitate gaseous exchange

Answer:

C.

Explanation:

You can use the series of elimination for this. First, you look at A. Technology is not an understanding of something new, so we cross that out. Second, you look at B. Technology isn't a series of steps, so we can mark that one off. Third, you look at C. Technology is something created using science for use by society, so we can keep that in mind. Lastly, we check D. Technology doesn't match up to the definition, so we can cross that one out. The answer that would make the most sense would be D.

Answer:

Organic

Explanation:

Edge student

Answer:

3

Explanation:

I wish you the best, its three or 2

Answer:

2

Explanation:

Edge 2021

Answer:

True

Explanation:

But have different neutrons

Answer: The equilibrium concentration of [tex]H_2(g)[/tex] at 700 degrees Celsius is 0.0012 M

Explanation:

Equilibrium constant is defined as the ratio of concentration of products to the concentration of reactants each raised to the power their stoichiometric ratios. It is expressed as [tex]K_c [/tex]

Moles of  [tex]H_2S[/tex] = 0.29 mole

Volume of solution = 3.0 L

Initial concentration of [tex]H_2S[/tex] = [tex]\frac{0.29mol}{3.0L}=0.097M[/tex]

The given balanced equilibrium reaction is,

                    [tex]2H_2S(g)\rightleftharpoons 2H_2(g)+S_2(g)[/tex]

         Initial conc.         0.097 M           0M          0M

At eqm. conc.    (0.097-2x) M            (2x) M   (x) M

The expression for [tex]K_c[/tex] is written as:

[tex]K_c=\frac{[H_2]^2\times [S_2]}{[H_2S]^2}[/tex]

[tex]K_c=\frac{(2x)^2\times x}{(0.097-2x)^2}[/tex]

[tex]9.30\times 10^{-8}=\frac{(2x)^2\times x}{(0.097-2x)^2}[/tex]

[tex]x=0.00060[/tex]

Equilibrium concentration of [tex][H_2][/tex]= 2x= [tex]2\times 0.00060=0.0012M[/tex]

Answer: Proton - positive charge (+)

Neutron - neutral charge (0)

Electron - negative charge (-)

Explanation: