LAST ATTEMPT! Covalent compound naming ! !!

Answer:

curium

−

243

,

252

/

99

Es,  

251

/

98

Cf,  

214

/

82

Pb

Explanation: Im not very good with this but here ya go!

The most reasonable step to take will be to check the calibration of the

thermometer to ensure that it is giving accurate readings.

Experiments which are done to be give the same results under standard

conditions. Common causes of incorrect results during the analysis of

boiling point of substances include heating the substance too rapidly or

the thermometer not being properly calibrated.

The thermometer is used to measure the temperature and so must be

properly calibrated to give accurate readings.

Read more on https://brainly.com/question/24657998

Answer:

n = 0.324 mol

Explanation:

PV = nRT

STP:

273.15K and 101.325kPa

n = PV/RT

n = (101.325kPa)(7.27L)/(8.314 L kPa/mol K)(273.15K)

n = 0.3243693408 mol

n = 0.324 mol

Hope that helps

Answer:

Molecules don’t have to collide with each other in order to experience intermolecular forces.

Molecules with permanent dipoles, held in fixed orientation, such as water molecules in the solid state (ice), interact with a potential proportional to the inverse cube of distance. This intermolecular force always exists, no matter how far apart the molecules are; every water molecule interacts with every other water molecule. However, because it diminishes rapidly with distance, it tends to only be important at short distances. (In contrast, the potential between two ions goes as 1/r, and that between an ion and a dipole goes as 1/r^2.)

The van der Waals forces, of which London dispersion forces are the most important, are described by a potential proportional to the inverse sixth power of distance. Theoretically, those forces are always operating between any two atoms or molecules, but again, only become important at short distances.

Explanation:

hope this helps

Answer:

the answer is correct part another is a part

Explanation:

c part

Answer:

since the distance between the electron and the nucleus is smaller in B than in Li, the electrostatic nuclear force of attraction experienced by B is higher than the one experienced by Li...this translates to the higher first ionization energy in B than in Li.

Explanation:

i hope it's helping!

Answer:

f the vapor pressure of water at 20.0 o C is 17.535 torr, and the atmospheric pressure measured by a barometer was 757.3 torr, what is the partial pressure of H2 in the gas mixture

Partial pressure of H2 in gas mixture is :

739.765 torr .

Total  pressure of mixture =

Partial of hydrogen + Partial pressure of oxygen

Partial of Hydrogen = Total pressure - partial   pressure  of  oxygen

Here total pressure = 757.3 torr

Partial pressure of oxygen = 17 . 535 torr

Total pressure = 757 . 3 - 17 . 533

                        = 739.765 torr.

To learn more about total pressure refer to :

https://brainly.com/question/22264785

#SPJ2

Answer:

your brain processes ever detail in a picture rather than words for for example a picture of something words doesn't describe it as well as the picture could.

A molecule is essentially created by a collection of atoms linked by a network of bonds.

Answer:

Because it goes through the process of sublimation.

Explanation:

The phenomena which  wind causes  are waves and surface currents.

Surface currents are caused by  winds  which blow over the ocean water and result in creation of waves. Surface currents  are horizontal streams of water which are capable of  flowing thousands of kilometers and can reach great depths.

Surface currents play a major role in determining the climate all over the world. They are influenced by three major factors 1) overall global wind patterns 2)rotation of earth 3)shape of ocean basins . When a surface  current collides with the land it  changes the direction of currents.

Because of surface currents the global climate has warmer water  from equator to the cooler parts of the ocean  as they transfer heat energy.

Learn more about surface currents,here:

https://brainly.com/question/1255202

#SPJ2

Answer:

When ionic compounds dissolve in water they go through a process called dissociation, splitting into the ions that make them up. However, when you place covalent compounds in water, they typically do not dissolve but form a layer on top of the water.

Answer:

clouds and precipitation that minimize temperature changes throughout the day

Explanation:

Answer:

The copper, because its specific heat is higher, meaning it takes more heat (Joules) per gram to raise the temperature 1 degree Celsius.

Explanation:

Answer:

First we know that the molar mass of CO2 is 44.01g/mol, and that the sample of CO2 contains 3.408 x 10^21 molecules, and we have to find the mass of that sample.

We know that moles = mass/molar mass, if we rearrange the equation for mass, we'll get:

mass = moles x molar mass

Also, note that the number of atoms/molecules in a sample is the moles of the sample x Avogadro's number (6.02 x 10^23)

If we rearrange the equation for moles, we would get:

moles = molecules of sample/6.02 x 10^23

Plug in the values for the equation above to get the moles:

moles = (3.408 x 10^21)/(6.02 x 10^23)

moles = 0.00566112956 (we're not done yet)

Now that we have the moles and we were already provided the molar mass, we can calculate the mass using the very first equation we rearranged.

mass = moles x molar mass

mass = 0.00566112956 x 44.01

mass = 0.2491g (answered 4 places past the decimal point)

Therefore the sample of Carbon Dioxide has a mass of 0.2491g

We can call a person by the word gentleman and Sir or from his/her real name.

If there is a name/surname you can't make out due to a speaker's manner of speech then I will call him gentleman or Sir or I will ask him his real name. Gentleman is a word that is used for noble person and Sir word is also used in order to give someone respect.

Call a person with his real name is also comes under the manner of speech so we can conclude that we can call a person by the word gentleman and Sir or from his/her real name.

Learn more about manner of speech here:

Learn more: https://brainly.com/question/26023566

Answer:: We're asked to find the molar concentration of the NaCl solution given some titration data.

Explanation:

Answer:

is easy to poiling

Explanation:

also is dificult to melting

Answer:

It has a total of three elements and seven atoms. Another use that aluminum hydroxide has is it treats the symptoms of too much stomach acid. Some examples of what it treats are: upset stomach, heartburn, and acid indigestion.

Explanation:

Atomicity is the no of atoms present in one molecule. Atomicity of Al(OH)3 = 7.

Answer:

the law of conservation of energy

Virtual and enlarged..............

What grade are you in btw ?

Answer:

predicting how a tech will interact with human tissue.

Explanation:

thats not really common except for in the medical field.

The challenge that is unique to the process of designing prostheses as opposed to engineering other technologies is Predicting how a technology will interact with human tissue. The correct option is option 4.

Prosthesis design is typically undertaken by shaping wax on a plaster replica of the patient's anatomy. Realism is predominantly achieved through the prosthetist's ability to interpret the correct location and physically recreate the anatomical shape and detail.

Prosthetic applications are an example of the intersection of design, technology and science.

Therefore, The challenge that is unique to the process of designing prostheses as opposed to engineering other technologies is Predicting how a technology will interact with human tissue. The correct option is option 4.

Learn more about Prosthetic Design, here:

https://brainly.com/question/20548709

#SPJ3

Answer:

3 significant figure

Explanation:

Trailing zeros in a number are significant ONLY is the number contains a decimal point.

So if it was 100cm with out the decimal point would only have 1 significant figure.

Answer:

c

Explanation:

The mass of CO₂ gas produced during the combustion of one gallon of octane is 8.21 kg.

The given parameters:

The mass of the octane burnt is calculated as follows;

[tex]m = \rho V\\\\m = 0.703 \ \frac{g}{ml} \times 3.79 \ L \ \frac{1000 \ ml}{L} \\\\m = 2,664.37 \ g[/tex]

The combustion reaction of octane is given as;

[tex]2C_8H_{18} + \ 25O_2 \ --> \ 16CO_2 \ + \ 18H_2O[/tex]

From the reaction above:

228.46 g of octane -------------------> 704 g of  CO₂ gas

2,664.37 of octane --------------------> ? of CO₂ gas

[tex]= \frac{2,664.37 \times 704}{228.46} \\\\= 8,210.3 \ g\\\\= 8.21 \ kg[/tex]

Thus, the mass of CO₂ gas produced during the combustion of one gallon of octane is 8.21 kg.

Learn more about combustion of organic compounds here: https://brainly.com/question/13272422

I believe the volume would turn out to be 2.35M but i could be wrong

Answer:

[tex][tex]\purple{\rule{45pt}{7pt}}\purple{\rule{45pt}{999999pt}}[tex][/tex]

Explanation:

[tex][tex]\purple{\rule{45pt}{7pt}}\purple{\rule{45pt}{999999pt}}[tex][/tex]