hi...need help....thank you..

Answer:

3) iron (iii) hydroxide

Explanation:

Answer:

13

Explanation:

234567877

Answer:38°

Explanation:

Answer:

Alkali metals are elements found in group 1 of the Periodic Table. Alkali metals are soft, malleable, ductile, and are good conductors of heat and electricity. They have low melting and boiling points compared to most other metals.

Heterogeneous, which means that they are not evenly combined.

Answer:

D

Explanation:

Answer: C: The inner core is densest due to gravitational compression

Explanation:  

Answer:

15.28 mL

Explanation:

From the question given above, the following data were obtained:

Molarity of stock solution (M₁) = 4.5x10¯⁴ M

Volume of diluted solution (V₂) = 275 mL

Molarity of diluted solution (M₂) = 2.5×10¯⁵ M

Volume of stock solution (V₁) needed =.?

The volume of the stock solution needed can be obtained by using the dilution formula as illustrated below:

M₁V₁ = M₂V₂

4.5x10¯⁴ × V₁ = 2.5×10¯⁵ × 275

4.5x10¯⁴ × V₁ = 0.006875

Divide both side by 4.5x10¯⁴

V₁ = 0.006875 / 4.5x10¯⁴

V₁ = 15.28 mL

Therefore, the volume of the stock solution needed is 15.28 mL

Answer:

A nucleus is a positive charge

Explanation:

A nucleus is made up of protons and neutrons. Protons have a positive charge and neutrons have a neutral charge.

Answer:

chemical structure determines the molecular geometry of ca compound by prtraying the arrangement of atoms and chemical bonds in the molecule..

Explanation:

hope this helps any <3

Answer:

The answer is 46.0055. We assume you are converting between grams NO2 and mole. You can view more details on each measurement unit: molecular weight of NO2 or mol This compound is also known as Nitrogen Dioxide.

Explanation:

hope this helps

Answer: Multiply the mass by the inverse of molar mass, and then multiply by Avogadro's number.

Explanation: Convert the mass to moles, multiply the number of moles by the ratio of the number of atoms or ions to one mole, multiply by Avogadro's number.

Answer:

creativity is the personal trait that scientists mainly depend upon when they design an experiment.

Answer: A decomposition reaction occurs when one reactant breaks down into two or more products.

Mark me as brainilist pls

Answer:

B.

Explanation:

Answer:

40.32L

Explanation:

So we know that 22.4 Liters is one mole of a gass so we can set up an equation to test that

1mole     1.8mole

_____ = _____

22.4L         x

and then cross multiply so you get 40.32L

Answer:

40.32L

Explanation:

Just did worksheet

Answer:

45 meters

Explanation:

Did the math

Answer:because they run out of energy when it is transferred and to other objects, or their kinetic energy

Explanation:

Answer:

Chemical element, metallic, symbol Mg, situated in group IIa in the periodic table, atomic number: 12, atomic weight: 24,312. ... Magnesium is known for a long time as the lighter structural metal in the industry, due to it's low weight and to it's capability of forming mechanically resistant alloys.

Answer:

you will get 17.983 g of lithium for every 100 g of lithium phosphate.

Explanation:

69.7%  is the percent by mass of Lithium in  Li[tex]_3[/tex]PO[tex]_3[/tex]. A percent is obtained by multiplying the result by 100.

One approach to show the concentration for an element within a compound or component in a combination is as a mass percentage. The mass percentage is computed by dividing the total weight of the combination by the mass of each component and multiplying the result by 100%. The mass percent is calculated by dividing the mass that contains the compound and solute by the mass for the element or solute.

99.795g/mol = molar mass of  Li[tex]_3[/tex]PO[tex]_3[/tex]

6.94g/mol = molar mass of Li

mass percentage of Li=(molar mass of Li/molar mass of Li[tex]_3[/tex]PO[tex]_3[/tex])×  100

=(6.94/99.7)×  100

=69.7%

To know more about mass percentage, here:

brainly.com/question/32197511

#SPJ6

Water boils when the vapour pressure is least the atmospheric pressure.

The atmospheric pressure is equal at the top of the mountain.

The air around you has weight, and it presses against everything it touches. That pressure is called atmospheric pressure, or air pressure. It is the force exerted on a surface by the air above it as gravity pulls it to Earth.

As we go up in altitude the air pressure becomes less. When the pressure decreases, it takes less energy to get the water molecules to escape the surface. So the temperature is less than it would be at sea level.

Air pressure is higher or greater at the bottom of a mountain. This is because the height of the air above that level is thicker than at the top.

Pressure is given by the equation, P=rho*g*h, where rho is the air density, g is the gravity value and h is the thickness of the air layer on top of the level where we are considering the pressure.

Therefore, as we can see, at the bottom of the mountain, the thickness h of air is greater, and so is the pressure.

Hence, water boils when the vapour pressure is least the atmospheric pressure and the atmospheric pressure is equal at the top of the mountain.

Learn more about the atmospheric pressure here:

https://brainly.com/question/11484577

#SPJ2

Answer:

I put B&C

Explanation:

Answer:

The evidence of matter scattering light wave in many different directions is;

D. The colors on the water's surface match the colors in the sky

Explanation:

Light scattering is used to describe the sending of a given beam of light in many directions (by tiny particles) when the light passes through a medium, due to the disruption of the bath of the light ray as it bumps into the tiny particles

Water has the nature of absorbing the red light. The light that enters the water is scattered by the tiny particles in the water such that the blue light which is the spectrum of light water allows to pass through is reflected along with the reflection of the sky and the colors of the water surface match the colors of the sky.

Answer:

C.

Explanation:

I took the quiz

Answer:

2 atoms

Explanation:

Because it contain one double bond

Answer:

Non-metals tend to gain electrons to attain Noble Gas configurations. The have relatively high Electron affinities and high Ionization energies. Metals tend to lose electrons and non-metals tend to gain electrons, so in reactions involving these two groups, there is electron transfer from the metal to the non-metal.

Answer:

metalloids

Explanation:

The kind of element most likely used to make semiconductors are the metalloids.

These elements have properties between those of metals and non-metals in that they are not truly metals and are partly non-metals.

Answer: S8 + O2 → S8O2: not 100% sure

Explanation:

A balanced chemical equation happens when the quantity of the particles is required on the reactants side is equivalent to the quantity is the molecules in the items side.

Answer:

Similarity: Rocks within the mantle contain more magnesium and iron than the ones in the crust.

Difference: Rocks in the deep mantle are under intense heat and pressure. In this case, they are semi-solid rocks that flow slowly. On the other hand, the part of the mantle that is nearest to the surface consists of rigid rocks. It has a lower temperature than the rocks in the deep mantle.

Explanation:

Rocks within the mantle contain more magnesium and iron than the ones in the crust.

Rocks in the deep mantle are under intense heat and pressure. In this case, they are semi-solid rocks that flow slowly.

On the other hand, the part of the mantle that is nearest to the surface consists of rigid rocks. It has a lower temperature than the rocks in the deep mantle.

According to geologists, a rock is a naturally occurring material made up of crystalline crystals of various minerals that have fused together to form a solid mass.

Therefore, Rocks within the mantle contain more magnesium and iron than the ones in the crust.

To learn more about rocks, refer to the link:

https://brainly.com/question/19930528

#SPJ2

Answer:

no

Explanation: