Will give brainliest, Look at the graph above. Compare it to the periodic table. What do you notice about the location on the periodic table of the elements that represent the high points
Answer:
We can see that the atomic radius decreases across every row.
Explanation:
I will comment more below.
The elements that represent the highest points on the graph are all elements of group 1 and occur at the head of the period to which they belong.
The periodic table is an arrangement of elements in groups and periods. The elements in the same group have the same number of valence electrons while the elements in the same period have the same number of shells.
Looking at the graph, we can see that the high points in the graph all correspond to the group 1 elements; sodium, potassium, rubidium and cesium.The have the highest atomic radii in the period. Atomic radii increases down the group but decreases across the period. Remember that these elements are at the head of the period to which they belong hence they have the highest atomic radii.
Learn more: https://brainly.com/question/9352088
every spring has an equilibrium position which statement describe a spring at it equilibruim position?
Why is it necessary to add concentrated HCl, then water, rather than a solution of HCl to the eudiometer tube
If we add water to a concentrated acid, then the solution may boil very violently, splashing concentrated acid. If add acid to water, the solution that forms is very dilute and a small amount of heat is released.
Why do we add acid to water?When a strong acid is poured into water, it flows down the flask and mixes much better, so no boiling takes place. The addition of water to acid forms an extremely concentrated solution of acid initially. A large amount of heat is released and the solution may boil very violently, splashing concentrated acid out of the beaker and all this because the reaction is exothermic in nature.
The reason this takes place is due to a large amount of energy liberated in the hydration reaction of concentrated ions. Therefore, we add acid to water dropwise for the dilution with constant stirring and not water to acid directly.
If we add water to acid, then an exothermic reaction occurs and the solution may boil very violently. To form the dilute solution of any strong acid, you should add acid to water and the small amount of heat released is not sufficient to vaporize and spatter it.
Learn more about dilution of acid, here:
https://brainly.com/question/
#SPJ2
PLEASE HELP ME!!!!!!!!!!!!!!!!!!!
WRITE A SHORT PASSAGE ON HOW FIBRES ARE SPUN
HELPPP WILL MARK AS BRAINLIEST
Answer: Spun yarn is made by twisting staple fibers together
To make a cohesive thread Or “single”. Twisting fibers, into yarn in the process called spinning can be dated back to the upper Paleolithic. Yarn spinning was one of the first processes to be industrialized.
Explanation:
What color do you get if you mix red and blue light?
Red and Green?
Blue and green?
What relationship do you find between frequency and energy?
What relationship do you find between wavelength and current flow?
What relationship do you find between light intensity and current flow?
Answer:
Purple light.
Yellow light.
Explanation:
Why does the flask have to be closed during the hydrochloric acid and sodium carbonate reaction?
Answer:
The flask has to be closed during the hydrochloric acid and sodium carbonate reaction as the resultant gas got trapped inside the closed flask.
Explanation:
The hydrochloric acid and sodium carbonate reaction was exothermic that caused the pressure to decrease. The flask has to be closed during the hydrochloric acid and sodium carbonate reaction as the resultant gas got trapped inside the closed flask.
In exothermic reactions, energy is produced in the form of heat or light.
A Barometer reads 29.1 inches of mercury.Calculate this pressure in mmHg.
What is the answer?
This follows a simple conversion technique. Basically what the question is trying to say here is to convert 29.1 inHg to mmHg. 1 inHg is equal to 25.4 mmHg so 29.1 inHg would be equal to [tex]25.4 * 29.1[/tex] which when evaluated turns out to be: [tex]739.14[/tex]. :D
The pressure will be 739.14 mm Hg.
What is pressure?The SI unit measuring pressure would be the pascal, which measures the force of each unit area of the surface.
Calculation of pressure
It is known that 1inHg = 25.4 mm Hg.
Hence, the pressure = 25.4 × 29.1 = 739.14 mm Hg
Therefore, the pressure will be 739.14 mm Hg.
To know more about pressure
https://brainly.com/question/15175692
#SPJ2
A 12 gram piece of Cu at 475 oC is placed in contact with a 15 gram piece of Cr at 265 oC.
Assume the two pieces of metal are the system and that there is no heat exchange between system and surrounding.
What is the final temperature of the two pieces of metal expressed in degree C?
Answer:
349.22°C
Explanation:
Let the final temperature of the two pieces of metal be x.
Now, the warmer metal which is C u reduces from 475°C to x. Thus Δt for C u is; Δt1 = 475 - x.
The cooler metal Cr increases in temperature from 265°C to x. Thus, it's change in temperature is Δt for Cr is; Δt2 = x - 265.
Now from conservation of energy, the amount of energy leaving the C u metal is equal to the amount of energy entering the Cr metal.
Thus;
q_lost = q_gain
Where;
q_lost = m1•c1•Δt1
q_gained = m2•c2•Δt2
Now, c1 & c2 are the specific heat capacity of C u and Cr respectively.
From online tables, c1 = 0.385 J/g°C and c2 = 0.46 J/g°C
We are given;
m1 = 12g and m2 = 15g
Thus;
12 × 0.385 × (475 - x) = 15 × 0.46 × (x - 265)
2194.5 - 4.62x = 6.9x - 1828.5
6.9x + 4.62x = 2194.5 + 1828.5
11.52x = 4023
x = 4023/11.52
x = 349.22°C
An excess of oxygen reacts with 451.4 g of lead, forming 374.7 g of lead(II) oxide. Calculate the percent yield of the reaction.
Answer: The percent yield of the reaction is 77.0 %
Explanation:
[tex]2Pb+O_2\rightarrow 2PbO[/tex]
[tex]\text{Number of moles}=\frac{\text{Given mass}}{\text{Molar mass}}[/tex]
[tex]\text{Number of moles of lead}=\frac{451.4g}{207.2g/mol}=2.18moles[/tex]
[tex]\text{Number of moles of lead oxide}=\frac{374.7g}{223.2g/mol}=1.68moles[/tex]
According to stoichiometry:
2 moles of [tex]Pb[/tex] produces = 2 moles of [tex]PbO_2[/tex]
2.18 moles of [tex]Pb[/tex] is produced by=[tex]\frac{2}{2}\times 2.18=2.18moles[/tex] of [tex]PbO_2[/tex]
Mass of [tex]PbO_2[/tex] =[tex]moles\times {\text {Molar mass}}=2.18\times 223.2g/mol=486.6[/tex]
percent yield =[tex]\frac{374.7g}{486.6g}\times 100=77.0\%[/tex]
A baseball has serval properties. Write one property that a baseball has.
complete sentences.