Geological and atmospheric changes happening over a ______ time scale can cause______ extinctions.


Fill in the blanks folks..

Answer:

a. The student's mistake was that the student did not swing the pendulum and start the watch at the same time.

b. 1.2 s per swing.

c. The likely effect of her reaction time is that they will should subtract two seconds off the time.

Explanation:

The pupil made the error of not simultaneously starting the watch and swinging the pendulum.

Pendulum is defined as a body that is suspended from a fixed point and moves back and forth while being pulled by gravity. The pendulum is used to gauge the gravitational pull because the force of gravity causes it to swing back toward its average position. A pendulum's time period can be used to tell the time because it is constant.

The swing of the pendulum is 1.2 sec. per swing. They should take two seconds off the timing due to her presumably slow reaction time. A pendulum's total time should be divided by the quantity of oscillations in order to determine its time period. When compared to a pendulum with a shorter string, the one back and forth cycle of a longer-stringed pendulum requires more time to complete.

Thus, the pupil made the error of not simultaneously starting the watch and swinging the pendulum.

To learn more about pupil, refer to the link below:

https://brainly.com/question/27874242

#SPJ2

Answer:

Explanation:

ok it's correct

Explanation:

v = u + at

25 = 75 + a * 5

25 = 75 + 5 a

a = 25 - 75/5

a = -50/5

a = -10m/sec^2

please mark me as a brainelist

Explanation:

HERE you go. hope this helps.

Answer:

Rt = 908.25 [ohm]

Explanation:

In order to solve this problem, we must remember that the resistors connected in series are added up arithmetically.

In this case, R2 and R3 are in series therefore.

R₂₃ = 200 + 470

R₂₃ = 670 [ohm]

Now this new resistor (R₂₃) is connected in parallel with the resistor R4. therefore we must use the following arithmetic expression, to add resistances in parallel.

[tex]\frac{1}{R_{4-23} }= \frac{1}{R_{4}}+\frac{1}{R_{23} } \\\frac{1}{R_{4-23} }=\frac{1}{1800}+\frac{1}{670} \\R_{4-23}=488.25[ohm][/tex]

In this way R₁, R₅ and R₄₋₂₃ are connected in series.

Rt = R₁ + R₅ + R₄₋₂₃

Rt = 150 + 270 + 488.25

Rt = 908.25 [ohm]

Answer:

Health relates to science because

in science you study, research, and knowledge in this case, health science, which helps you under stand more about how humans and animals function. And Physical education relates to science because , you study the way of human movement, think of push-ups as a example.

I hope I helped U ´꓃ ` U

Answer:

the density is 0.301 :)

Answer:

letterman is shooting the kids

We use insulators to avoid being electrocuted. electricians use rubber gloves to avoid shock. Cables are insolated with rubber so you can hold them without getting shocked even if it is plugged in.

Answer:

tura paulo

Explanation:

sry if im wrong ;)

it would be on the ground

Answer:

A................

Explanation:

Hope this helps you

A. increase it's current and increase it's voltage

Explanation:

Answer:

Black holes are some of the strangest and most fascinating objects in outer space. They're extremely dense, with such strong gravitational attraction that even light cannot escape their grasp if it comes near enough. so when in books, movies, songs, video games, comics, paintings, etc you can imagine the impossible. as in escaping a black hole

Explanation:

Answer:

its D

Explanation:

i took the assignment, its D

Answer:

d = 120 [m]

Explanation:

In order to solve this problem, we must use the theorem of work and energy conservation. Where the energy in the final state (when the skater stops) is equal to the sum of the mechanical energy in the initial state plus the work done on the skater in the initial state.

The mechanical energy is equal to the sum of the potential energy plus the kinetic energy.  As the track is horizontal there is no unevenness, in this way, there is no potential energy.

E₁ + W₁₋₂ = E₂

where:

E₁  = mechanical energy in the initial state [J] (units of Joules)

W₁₋₂ = work done between the states 1 and 2 [J]

E₂  = mechanical energy in the final state = 0

E₁ = Ek = kinetic energy [J]

E₁ = 0.5*m*v²

where:

m = mass = 60 [kg]

v = initial velocity = 12 [m/s]

Now, the work done is given by the product of the friction force by the distance. In this case, the work is negative because the friction force is acting in opposite direction to the movement of the skater.

W₁₋₂ = -f*d

where:

f = friction force = 36 [N]

d = distance [m]

Now we have:

0.5*m*v² - (f*d) = 0

0.5*60*(12)² - (36*d) = 0

4320 = 36*d

d = 120 [m]

Answer: a piece of iron near a magnet

Explanation:

Answer:

C

Explanation:

Balanced forces cancel each other out so they do not change the object's motion

‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎1500 kpm

Answer:

Negatively charged, to positively charged parts

Explanation:

Electrons are negative, negative is attracted to positive.

Answer:

1) 2197.44 J

2) 0 J

3) 2197.44 J = Constant

4) 2197.44 J

5) Approximately 8.86 m/s

Explanation:

The given parameters are;

The mass of the diver, m = 56 kg

The height of the cliff, h = 4.0 m

The speed with which the diver is moving, vₓ = 8.0 m/s

The gravitational potential energy = Mass, m × Height of the cliff, h × Acceleration due to gravity, g

1) Her gravitational potential energy = 56 × 4.0 × 9.81 = 2197.44 J

2) The kinetic energy = 1/2·m·u²

Where;

u = Her initial velocity = 0 when she just leaves the cliff

Therefore;

Her kinetic energy when she just leaves the cliff = 1/2 × 56 × 0² = 0 J

3) The total mechanical energy = Kinetic energy + Potential energy

The total mechanical energy is constant

Her total mechanical energy relative to the water surface when she leaves the cliff = Her gravitational potential energy = 2197.44 J = Constant

4) Her total mechanical energy relative to the water surface just before she enters the water = 2197.44 J

5) The speed with which she enters the water, v, is given from, v² = u² + 2·g·h

Where;

u = The initial velocity at the top of the cliff before she jumps= 0 m/s

∴ v² = 0² + 2 × 9.81 × 4 = 78.48

v = √78.48 ≈ 8.86 m/s

The speed with which she enters the water, v ≈ 8.86 m/s

1) Her gravitational potential energy relative to the water surface when she leaves the cliff is; GPE(leaves cliff) = 2195.2 J

2) Her kinetic energy when she leaves the cliff is; KE = 0J

3) Her total mechanical energy relative to the water surface when she leaves the cliff is; ME_total = 2195.2 J

4) Her total mechanical energy relative to the water surface just before she enters the water is; ME_total = 2195.2 J

5) The speed at which she enters the water is; v = 8.85 m/s

We are given;

Mass of the diver; m = 56 kg

Height of the cliff; h = 4 m

Speed at which she is moving; vₓ = 8 m/s

1) Formula for gravitational potential energy is;

GPE = mgh

where;

m is mass

g is acceleration due to gravity

h is height

Thus;

GPE = 56 × 4 × 9.8

GPE(leaves cliff) = 2195.2 J

2) The formula for kinetic energy when she leaves the cliff is;

KE = ¹/₂mu²

Where;

m is mass

u = initial velocity = 0 m/s

Thus;

KE = ¹/₂ × 56 × 0²

KE(leaves cliff) = 0 J

3) The total mechanical energy relative to the water surface when she leaves the cliffis;

ME_total = GPE(leaves cliff) + KE(leaves cliff)

Thus;

ME_total = 2195.2 + 0

ME_total = 2195.2 J  

4) Her total mechanical energy relative to the water surface just before she enters the water is same as that when she leaves the cliff = 2195.2 J

5) The speed with which she enters the water, v, is gotten from newtons third equation of motion;

v² = u² + 2gh

Thus;

v² = 0² + (2 × 9.8 × 4)

v² = 78.4

v = √78.4

v = 8.85 m/s

Read more at; https://brainly.com/question/25708521

Explanation:

by finding the distance between two successful crest

Answer:

the wavelength can be measured as the distance from crest to crest  or from trough to trough , the wavelength of a wave can be measured as the distance from a point on a wave to the corresponding point on the next cycle of the wave.

Explanation:

Answer:

An element's valence electron tells us about its ability to react and not react. More rules to this, but that's the gist of it. it also helps us form bonds

Explanation:

Valence electrons are used by an element for bonding and ionization, contributing to the element's chemical reactivity and behavior.

Valence electrons also play a vital role in ionization, which refers to the process of gaining or losing electrons to form ions. Elements tend to gain or lose electrons in order to achieve a stable electron configuration, typically by acquiring a full valence shell.

Metals, located on the left side of the periodic table, have fewer valence electrons, often one or two, and tend to lose them to form positive ions (cations). This characteristic makes them good conductors of electricity.

Nonmetals, located on the right side of the periodic table, have a nearly full valence shell and tend to gain electrons to achieve a stable configuration, forming negative ions (anions). Nonmetals generally do not conduct electricity as well as metals.

In summary, valence electrons are used by an element for bonding, where they participate in the formation of covalent and ionic bonds, and for ionization, where they are gained or lost to form ions and achieve a stable electron configuration.

To know more about electrons here

https://brainly.com/question/12001116

#SPJ6

Answer:

Range of projectile, R

For projection above ground surface, the range of the angle of projection with respect to horizontal direction, θ, is 0° ≤ θ ≤ 90° and the corresponding range of 2θ is 0° ≤ 2θ ≤ 180°.S

hope you're looking for this.

Answer:

12m/s2

Explanation:

:D (just a smiley, not answer d)