There are 1.56 moles of solute present in a 2300 mL solution of 0.68M MgSO4.
How to calculate number of moles?The number of moles of a substance can be calculated by using the following formula:
molarity = no. of moles / volume
According to this question, a volume of 2300 mL solution is contained in 0.68 M MgSO4. The number of moles is calculated as follows:
no of moles = 0.68M × 2.3
no. of moles = 1.56
Therefore, there are 1.56 moles of solute present in a 2300 mL solution of 0.68M MgSO4.
Learn more about moles at: https://brainly.com/question/12127540
What is the ph of a solution of h2so4 that has [h3o ] = 5.45 × 10–5 m? round to the nearest hundredth.
The pH of a solution of H₂SO₄ that has [H₃O⁺] is 5.45 × 10⁻⁵ M, is 4.26.
What is pH?pH is define as the negative logarithm of the concentration of H⁺ or H₃O⁺ ions, and it is represented as:
pH = -log[H⁺]
Concentration of H₃O⁺ in H₂SO₄ solution = 5.45 × 10⁻⁵ M
pH of H₂SO₄ solution will be calculated as:
pH = -log(5.45 × 10⁻⁵)
pH = -(-4.26)
pH = 4.26
Hence required pH is 4.26.
To know more about pH, visit the below link:
https://brainly.com/question/522383
Answer:
4.26 is the answer
Explanation:
edge 2022
"Ozone Depletion."
Spray bottles, air conditioners, and
refrigerators used to contain CFCs
and halogens. These chemicals
destroyed ozone and broke apart the
ozone layer. They made two large
holes at the North and South Poles.
However, most of these chemicals
are now not allowed.
What is the MOST accurate summary of this
paragraph?
Answer:
CFCs and halogens coming from spray bottles and other human satisfaction sustaining devices cause global warming, which will cause sea levels to rise. Because of this, several countries have banned these chemicals because of anticipation of a rise of sea levels and several important countries to be sunken.
A heated metal object whose temperature is 50 °C is dropped into
a tub of water whose temperature is 0°C. What will happen to the
temperature of the metal and water after 5 minutes?
answer: the oject would break because of the amount of cooling added to the mass so after five minutes it would start to crust a little bit. and the temprature would decrese jarastically
Explanation:
yes
Which units are used for weight? Give the full name, not the abbreviation.
Answer:
Gram, Kilogram, and Tonne
Explanation:
Answer:
The unit of measurement for weight is that of force, which in the International System of Units (SI) is the newton. For example, an object with a mass of one kilogram has a weight of about 9.8 newtons on the surface of the Earth, and about one-sixth as much on the Moon.
Explanation:
Which element cannot be the central atom of a lewis structure?.
Answer:
Hydrogen
Explanation:
Hydrogen can never be central atom despite its low electronegativity
word equation for magnesium carbonate and nitrate (V)acid.
Answer:
This is an acid-base reaction (neutralization): MgCO 3 is a base, HNO 3 is an acid.
Explanation:
HNO3 + MgCO3 → H2O + CO2 + Mg(NO3)2
What is qualitative and quantitative?
Answer:
Quantitative data refers to any information that can be quantified, counted or measured, and given a numerical value. Qualitative data is descriptive in nature, expressed in terms of language rather than numerical values
Explanation:
:)
What happens in radioactive decay?
Answer:
When it decays, a radionuclide transforms into a different atom - a decay product. The atoms keep transforming to new decay products until they reach a stable state and are no longer radioactive. The majority of radionuclides only decay once before becoming stable.
Why is carbon dioxide a necessary part of the atmosphere.
Answer:
helps to trap heat in our atmosphere
hello people ~
Identify the gas that is generally produced when coal is burnt in the presence of a lot of air.
A. Carbon monoxide
B. Sulphur dioxide
C. Nitrogen dioxide
D. Carbon dioxide
Answer:
Carbon dioxide
Explanation:
The reaction is given by
C+O_2-->C0_2CO2 is a harmful gas also responsible for the global warming and air pollution
When coal is burnt in the presence of excess air, some of the gases produced include carbon dioxide, oxides of nitrogen, and sulfur dioxide.
What are the gaseous products from coal burning?When coal is burnt in the presence of a lot of air, a variety of gases are produced: These include:
Carbon dioxide which is the major productOxides of nitrogenOxide of sulfurAside from carbon dioxide, other gases depend on the content of coal.
More on the burning of coal can be found here: https://brainly.com/question/1419068
#SPJ5
How do acquired characteristics differ from adaptations
Answer:
acquired traits are traits that organisms develops over a lifetime. adaptation are trait that enhances an organism's ability to survive and reproduce in its environment.
the states of matter involved in a milkshake
Answer:
it is a liquid that is made from the combination of a liquid and a solid.
Explanation:
When these two states of matter are ground and mixed together, they form one state that is liquid
Answer:
Solid and liquid
Explanation:
Solid= ice cream or ice
Liquid= milk
these are common things used in a milkshake
How much hcl must be added to a liter of buffer that is 1. 5 m in acetic acid and 0. 70 m in sodium acetate to result in a buffer ph of 4. 01?]
For a liter of a buffer that is 1. 5 m in acetic acid and 0. 70 m in sodium acetate, and with a result in a buffer pH of 4.01, the moles of HCl required is mathematically given as x=0.313mol
What is the result in a buffer ph of 4. 01?Generally, the equation for the pH is mathematically given as
pH=pKa+logsalt/acid
Generally, the equation for the Chemical Reaction is mathematically given as
HCl+CH3CooNa---->NaCl+CH3OOH
Therefore
4.01=4.74+log\frac{0.8-x}{1.3+x}
-0.52=log\frac{0.8-x}{1.3+x}
x=0.313mol
In conclusion, The moles of HCl required is
x=0.313mol
Read more about Chemical Reaction
https://brainly.com/question/6876669
Buffer is a solution that prevents pH variation in a solution when base or acid is added. In a liter of buffer 0.313 mol of hydrochloric acid must be added.
What is pH?pH is the potential of hydrogen and is given as,
[tex]\rm pH =\rm pKa + log \dfrac{salt}{acid}[/tex]
The chemical reaction is given as,
[tex]\rm HCl+CH_{3}COONa \rightarrow NaCl+CH_{3}OOH[/tex]
Given,
pH =4.01
pKa = 4.74
Concentration of salt = 0.8 - x
Concentration of acid = 1.3 + x
Substituting values in the pH formula:
[tex]\begin{aligned} 4.01 &= 4.74 + \rm log \dfrac{(0.8 - x)}{ (1.3 + x)}\\\\-0.52 &= \rm log \dfrac{(0.8 - x)}{ (1.3 + x)}\\\\&= 0.313 \;\rm mol\end{aligned}[/tex]
Therefore, 0.313 moles of HCl are needed.
Learn more about buffers here:
https://brainly.com/question/9875355
#SPJ4
(PLEASE ANSWER!)
2H20 + 2Na --> 2NaOH + H2
which of these is a reactant in this chemical reaction?
A. hydrogen
B. nitrogen
C. oxygen
D. water
Answer:
Water (H2O) and Sodium (Na) are reactants.
Explanation:
2H2O+2Na......2NaOH+H2
In the above reaction the water (H2O) and sodium (Na) are reactants and sodium hydroxide (NaOH) and hydrogen are products.
And this is the single displacement reaction.
Which hydrogen of 1-chloropent-2-ene shows the largest chemical (downfield) shift in its nmr spectrum?
The hydrogen of 1-chloropent-2-ene shows the largest chemical shift is C2 or C3 because they are more de-shielded than they have the largest chemical shift value.
Which hydrogen of 1-chloropent-2-ene shows the largest chemical shift in its nmr spectrum?Generally, There is the biggest chemical shift at C2 or C3 due to the fact they are connected through the pi- bond and range is about 4.5 - 6 ppm and C1 has a range of about 3.5 due to Cl- ion.
In conclusion, C2 or C3 is more de-shielded than they have the largest chemical shift value.
Read more about Compound
https://brainly.com/question/704297
I NEED THE AWNSER RIGHT NOWWWWW Four students categorized several environmental changes as short-term or long-term changes. Which chart correctly categorizes short- and long-term changes?
Based on the duration and effect of the environmental change, the correct categorization is as follows:
Short-term changes - Fire, flood, pollution of waterways, disease Long-term changes- extinction, early frost, deforestation, desertificationWhat are environmental changes?Environmental changes refers to changes that occur in the environment either due to natural causes or by human activities.
Environmental changes can be categorized into:
short-term changes andlong-term changesShort-term changes occur over a short period of time while long-term changes occur over a long period of time.
Based on the chart, the correct categorization is as follows:
Short-term changes - Fire, flood, pollution of waterways, disease Long-term changes- extinction, early frost, deforestation, desertificationTherefore, both long-term and short-term changes occur in the environment.
Learn more about environmental changes at: https://brainly.com/question/15825233
Which of the following is not manufactured from high-density polythene?
A. Containers
B. Pipes
C. Candles
D. Toys
Hey there!
C. Candle
Explanation:
Answer. High-density polyethylene or HDPE is a thermoplastic polymer used in the production of plastic bottles, containers, corrosion-resistant pipes, etc. and not used for the production of candles. Commercially available candles are made with paraffin wax.
How many potassium ions are needed to bond with a phosphate ion?.
How much heat energy is needed to change 10 kg of ice at to water at ? , ,
we know that,
W = mL + mcθ
W= 10(336+ 4.2(50))= 5460 kJ
so quantity of heat required is 5460 J
Was this helpful?
During which process in the water cycle does water release thermal energy? Explain how you know.
Answer:
evaporation
Explanation:
Evaporation occurs when a liquid changes to a gas. During evaporation, molecules gain enough thermal energy to escape from the liquid surface into the air as water vapor.
hope this helps
Which of the following is a pure substance?
O A. Milk
O B. Salt
O C. Blood
O D. Candy bar
Answer:
A. Milk
Explanation:
Cause is basics. It's proved by scientific I watched on TV and my teacher told me. I am a 100% sure.Go ask to your mother how many litres you drink her milk per day.
What is the Electronegativity difference of C and S?
Answer:
S 2.6 [2.58] & C is 2.6 [2.55]
Explanation:
What is primarily released in radioactive decay?
Answer:
When radioactive atoms decay, they release energy in the form of ionizing radiation (alpha particles, beta particles and/or gamma rays). The energy is called ionizing radiation because it has enough energy to knock tightly bound electrons from an atom's orbit. This causes the atom to become a charged ion.
Explanation:
Complete the mechanism for the reaction of butanone with NaBH4 followed by the addition of aqueous acid. Butanone is a 4 carbon chain where carbon 2 is double bonded to oxygen. This reacts with N a B H 4, followed by H 3 O plus to give the final product. Step 1: draw curved arrows. ⟶ Step 2: Draw the charged organic intermediate product. Include nonbonding electrons and charges. Omit the counterion. −→−−H3O+ Step 3: Draw the final product
The formation of a primary alcohol from a ketone involves the use of a ketone and NaBH4 followed by an acid workup.
Formation of a primary alcoholThe question is unclear but clearly relates to the formation of a primary alcohol. The first step in this reaction is the attack of the NaBH4 on the carbonyl carbon of butanone.
The reaction sequence is completed by an acid work up in which an acidic hydrogen is abstracted by the nucleophile to yield a primary alcohol.
Learn more about primary alcohol:https://brainly.com/question/7207863
Hi hello this system to have to ask question for answers is not good. I’m poor
Answer:
so what do you need help with?
Explanation:
Answer:
what do you need help with i will try to answer
Explanation:
10) How can you find the density of any gas at standard conditions?
N2 (g) + 3H2 (g) ⇔ 2NH3 (g) + Energy
Complete the table below by filling in "right" or "left" for the equilibrium shift and "increases" or "decreases" for the concentration of reactants and products.
Answer:
b is the answer
Pls help ASAP I’ll mark BRAINLIEST this is science btw.
Answer:
It should be Magnetic fields can push and pull objects without touching
but I only say with touching. Maybe it's an error on you're teachers/Prof behalf.
What causes “gaps in the rock record” and how is that described?
Answer:
An unconformity is a widespread surface separating rocks above and below, which represents a gap in the rock record. Unconformities occur when either erosion wears away rocks, or rock deposits never form. Therefore, a time gap exists between when the rocks below the unconformity formed and when those above it formed.
Explanation:
Strong bases are ____________ of group ____________ metals (ex. ____________ ) or larger group ____________ metals (ex. ____________ ), or oxides of the same metals.
The strong bases are hydroxides of group 1 and 2 metals (ex. Sodium, Potassium) or larger group transition metals (Copper, Iron), or oxides of the same metals.
Strong bases formulationIt follows from structure of strong bases that they are composed of highly electropositive metals of groups 1 and 2 and the hydroxide ion.
Additionally, transition metals may also form bases with the hydroxide ion or oxides of this transition metals.
Read more on strong bases;
https://brainly.com/question/15192126